资源列表
基于ST89C52的数字时钟
- 使用ds12c887时钟芯片 1602LCD液晶显示时分秒年月日 可设置闹钟
温度测量
- 基于stc12c5108s2单片机的温度测量的原理图和程序，使用单片机和TMP35和pt100实现温度测量，包括原理图、C语言程序和测试结果(Based on the schematic diagram and program of temperature measurement based on stc12c5108s2 single chip microcomputer, the temperature measurement is realized by using single chip
转速测量
- 基于stc12c5a08s2单片机使用M/T法测量频率(Based on STC12C5A08S2 microcontroller, M/T method was used to measure the rotating speed)
正弦交流信号检测
- 利用单片机stc12c5a08s2测量正弦交流信号的瞬时值和有效值，并拟合曲线(The instantaneous value and effective value of sinusoidal AC signal are measured by single chip microcomputer stc12c5a08s2, and the curve is fitted)
电池电压信号检测
- 使用单片机stc12c5a08s2设计预处理电路测量电池电压，并拟合曲线(Using the single chip microcomputer stc12c5a08s2 to design the pretreatment circuit to measure the battery voltage and fit the curve.)
kubo
- kubo公式推导石墨烯电导率.txt
ADS1118 F407 口线模拟 spi
- 主控cpu采用stm32f407vet6,采用口线模拟的spi总线来采集ads1118的俩路输入模拟信号。信号输入范围为0--2.048V。对应0--65535.(The main control cpu adopts stm32f407vet6, and adopts the spi bus of port line simulation to collect the two input analog signals of ads1118. The signal input range is
手势控制小车
- 本设计包含两个部分，手势遥控器（利用mpu6050读取手势信息）利用蓝牙模块将控制信号发送到小车端，小车端接收到控制信号后做出相应的动作。(This design includes two parts, gesture remote controller (using mpu6050 to read gesture information) uses Bluetooth module to send the control signal to the car end, and the car e
BootLoader-ymode
- bootloader串口助手+Ymodem协议(BootLoader+Ymodem agrement)
3-TIM—通用定时器-输入捕获-测量脉冲宽度
- stm32f103通用定时器脉宽测量输入捕获实验(STM32F103 general timer pulse width measurement input acquisition experiment)
STM32F1开发指南(精英版)-库函数版本_V1.0
- stm32f103开发指南（精英版）-库函数版本——v1.0(STM32F103 Development Guide (Elite version) - library function version -- v1.0)
max31855热电偶程序
- max31855热电偶程序max31855热电偶程序max31855热电偶程序