资源列表
DSP
- 利用巴特沃思、切比雪夫或椭圆滤波器设计数字滤波器,通过改变滤波器参数或特性（低通、高通、带通或带阻等）-The use of Butterworth, Chebyshev or elliptic filter digital filter design, by changing the filter parameters or characteristics (low pass, high pass, band-pass or band stop)
zbardmeo
- zbar源代码移植并在DSP上实现，实验结果显示能够很好的在DSP上解码-The zbar source code is ported and implemented on the DSP
dc-dc-500V
- 输出500V的dcdc直流变流器，采用交错PWM程序控制，具有很好的参考价值。-Output 500d dcdc DC converter, the use of interleaved PWM program control, has a good reference value.
TMS320F28035-MPPT
- TMS320F28035芯片的太阳能MPPT逆变器程序，具有很好的参开价值。-TMS320F28035 chip solar MPPT inverter program, has a very good reference value.
SPWMxiao
- DSP28335在ccs6.0开发环境下编写生成PWM波形-DSP28335 in ccs6.0 development environment to generate PWM waveform generation
DFIM_VC
- 自己做的一个双馈电机的矢量控制，可以跑，PI参数和电机系数可以自行修改修改，波形会更好。-This is a DFIM FOC simulation program based on MATLAB simulink.It contains the SVPWM program.
TMS320F28x_boot
- TMS320F28xx系列的DSP在线升级boot程序，通过串口实现和上位机软件的通信并实现软件在线升级，boot程序分配在Flash的sectorA区，应用程序分配在其他区。 新建CCS工程并将几个文件夹加入编译即可。-TMS320F28xx Series DSP Online Upgrade boot program, and communication through the serial port of the PC software and implementing softwar
ProDSP_F28027_MPPT
- TI F28027 光做MPPT程序，实际闭环跟踪光伏功率，是可以实用的程序-TI F28027 light to do MPPT procedures, the actual closed loop tracking photovoltaic power, the program can be useful
DSP_sine
- DSP程序，放在TXT文件，可调试，功能是产生频率幅值和相位可调的正弦波-DSP procedures, on the TXT file, debugging, the function is to generate frequency amplitude and phase adjustable sine wave
DFIGinPLECS
- 基于PLECS的双馈式风机的并网程序，可以学习并借鉴的-DFIG in PLECS
volume
- 这是DSP基础声波音频程序volume。通过读取外部文件sin.dat，可以在CCS中显示出文件中的波形，本例为正弦波。-This is the DSP based sound wave audio program volume. By reading the external file sin.dat, you can display the waveform in the file in CCS. This example is a sine wave.
FPGA_Converter_1110
- 利用FPGA编写的逆变器控制程序,可输出三相对称正弦电压-The code of inverter control program written in FPGA，Can output three-phase sinusoidal voltage