资源列表
cSharp
- C#编写的上位机软件以及单片机通讯的程序-This feature is a host computer program with the single-chip communications program written in C#
ucos-LCD-ADC
- 基于LPC2124的ADC波形采样,以ucos为操作系统,利用定时器1设定采样时间,将采集到的波形显示在LCD上。-LPC2124-based ADC waveform sampling ucos operating system, use the timer to set the sampling time will be collected from the waveform displayed on the LCD.
plus
- stm32 2进制加法小程序....初步入门的可以参照一下。-stm32
Position-Adjust
- 永磁同步电机的零位确定,u v和u w和v w分别接正负,然后计算得到的平均值即为电机零位-Mesure the PMSM zero position
S3C2440-EtherCAT-
- 基于ARM的S3C440处理器实现EtherCAT智能从站,协议芯片为赫优讯的netx-EtherCAT slave used the ARM and netX
WATER-LINGTS
- 主要是用于52、51、或54单片机的汇编程序,例如流水灯!-Is mainly used for 52,51, or 54 single-chip assembler, such as water lights!
ExampleCode_ADF7023
- 用c语言写的关于ADF7023应用的一个例子-An example of c language written on the application of ADF7023
cepin
- msp430 测频程序,用12864作为显示部分-msp430 frequency measurement procedure, use 12864 as the display section
1.13--IIC
- 基于S3C2440的IIC接口的基本操作编程,吧数据写到AT24C02中,然后读出写入的数据并通过串口发送到PC上。-Based on the basic operation of the IIC interface of S3C2440 programming, data written to the AT24C02 in, and then read out the written data and sent through the serial port to a PC.
PID_1602
- 温度控制 pid 1602lcd显示 单片机控制-pid 1602
MSP430G2553-Mixed-Signal-Microcontro
- MSP430G2553单片机数据手册(详细)-MSP430G2553 MCU Data Sheet (detailed)
LPC2138--proteus-6.8---ADC-stimu
- LPC2138 AD 源代码 proteus 仿真成功-LPC2138 AD source code proteus simulation