资源列表
ADS1115
- ADS115的驱动程序，已经调通了，默认是通道一-ADS115 driver, has been transferred, the default is to channel a
mpu6050
- 51单品机通过mpu6050采集三轴陀螺仪，三轴加速度，并利用串口输出-51 mpu6050 collected by a single product machine axis gyroscope, three-axis accelerometer, and use the serial output
UDP
- stm32与w5500模块通信的UDP例程，亲测可用-UDP routines stm32 module to communicate with the w5500, pro-test available
C51-ILI9488
- ILI9488驱动（C语言），基于C8051F-ILI9488 driver, based on C8051F
zigbee-DS18b20-DS2482
- 通过一总线接口DS2482驱动DS18B20温度传感器，通过Zigbee无线发射。-DS2482 DS18B20 Zigbee
u8glib_arduino_v1.15
- Arduino单片机OLED、LCD12864等驱动程序，大量现成的界面程序，使用方便 -Arduino microcontroller OLED, LCD12864 and other drivers, a large number of ready-made interface program, easy to use
STM32BootLoader
- stm32 利用zmodem下载固件升级-stm32 use zmodem download firmware update
ads1118
- ADS1118 MSP430的应用程序-this is ADS1115 for msp430g2553.
PGA2310
- 这个是用51单片机控制的可编程增益放大器PGA2310的程序，采用SPI控制方式，将增益显示在数码管上，并用两个独立按键控制步进的增益值。-This is a single-chip control with 51 programmable gain amplifier PGA2310 program, using SPI control mode, the gain on the digital display and control the stepper gain value with t
Stm32
- 基于STM32的温度、湿度的检测系统的设计论文，各方面都有详细介绍和设计-STM32-based temperature and humidity detection system design papers, all aspects in detail and design
stemotor
- 步进电机细分控制器，硬件采用TMS320F2815，软件是在CCS3.3平台上的C语言。-Step motor subdivision controller,based on the tms320f2815 and CCS3.3
TDC_GP2_OK
- 针对德国ACAM公司的TDC_GP2芯片写的80C51单片机开发源程序，包括六个寄存器的正确配置，SPI、串口等通信。非常好，已调试成功，通过串口调试助手即可直接接收到时差数据。测量范围2:500ns-4ms。只需改变寄存器1即可实现测量范围1:0-500ns的测量。-TDC to Germany ACAM companies GP2 chip 80 c51 source program development, including the correct configuration of th