资源列表
heater
- 温度控制器程序，包括PID算法，控制精度可达到0.01度-Temperature controller procedures, including the PID algorithm, the control precision can reach 0.01 degrees
MT8816
- MT8816矩阵芯片（8*16路双向通道）51单片机控制c程序-MT8816 Matrix chips (8* 16 bi-directional channels) 51 MCU control c program
HC6800v2.8
- 普中科技51单片机开发板HC6800EV2.8的配套说明文档，pdf格式。-Science and technology in general 51 MCU development board HC6800EV2.8 supporting documentation, pdf format.
Control-based-MPPT-Charge-Controller-for-solar-pho
- 一种基于MPPT控制的太阳能光伏充电控制器研制-Control based MPPT Charge Controller for solar photovoltaic
bianwuxian
- LED红黄蓝白扁五线彩虹管幻彩控制器的控制程序-Five-LED red, yellow, blue and white wire rope flat Symphony controller control program
NC-500w-60HZ
- 这是用松翰2711/14P写的一个方波逆变器的整机电路程序，有电压高低检测，过流检测，短路检测，-This is a song written by John 2711/14P square wave inverter circuit whole process, there is a voltage level detection, over current detection, short circuit testing,
ds1307
- DS1307驱动程序，提供通用的接口，使用时只需要改变引脚即可-DS1307
multisim
- 基于Multisim软件设计的数字秒表电路课程设计报告-Multisim software design based on digital stopwatch circuit course design report
LedDriver
- 舞台RGB大功率LED控制程序，已成熟应用于产品上，带温度补偿PID算法，支持DMX行业标准协议，内置多可是调场景，LCD菜单，eeprom变量保存-Stage RGB high power LED control procedure, has grown applied to products, with temperature compensation PID algorithm, support DMX industry standard agreement, built-in much
robot
- labview编写的机器人手臂运动源码，可模拟手臂的动作及控制过程-robot arm motion labview write source code, can simulate the arm motion and control process
modbus
- STC 单片机通过modbus总线和上位机进行通信的程序-SCM STC bus and host computer through the modbus communication procedures
dht11
- dht11温湿度传感器的89c52单片机和L1602显示程序测试-dht11 display program 1602 microcontroller connections