资源列表
X9C103
- 利用51单片机和两个独立按键控制数字电位器X9C103的电阻输出，步进位100Ω。-The use of 51 microcontroller and two separate buttons to control the digital potentiometer X9C103 resistor output, step-bit 100Ω.
balance-car
- 多套两轮平衡车，扭扭车的源码和学习资料，希望对大家有帮助-Several sets of two balanced car, shilly car source and learning materials, we hope to help
FFT-Code
- 可以通过STM32的AD采集测出正弦波的频率，并在液晶屏上显示出来。（原子的mini板可直接用）-AD can gather through the STM32 measured sine wave frequency, and displayed on the LCD screen. (Atoms mini board can be directly used)
STM32F407PJY-901
- STM32F407+JY-901，使用STM32F407单片机使用UART串口读取JY-901九轴姿态传感器的加速度，角加速度等数据。-STM32F407+JY-901, using the STM32F407 microcontroller using the UART serial port to read JY-901 9-axis attitude sensors acceleration, angular acceleration data.
MK5238AProgram
- 罗姆锂电保护模拟前端的ML5238的MCU代码例程-Rom battery protection ML5238 analog front end MCU code routines
Max31865
- MAX31865+PT100+STM32驱动，加中文数据手册-MAX31865+PT100+STM32 Driver，Chinese datasheet
AD7799--SPI
- msp430f169控制24位ad芯片AD7799应用程序（使用SPI接口）- msp430f169 control 24 ad chip AD7799 applications (SPI interface)
Sch
- 台湾中颖单片机79F1611驱动电流有感无刷电机的原厂原理图和PCB图。-Taiwan Sinowealth 79F1611 microcontroller drive current brushless motor felt the original schematics and PCB.
stm32-bldc
- 基于stm32 的直流无刷电机驱动程序,BLDC 三相直流无刷电机，无霍尔传感器，速度PID环-Based stm32 DC brushless motor driver, BLDC phase DC brushless motor without Hall sensors, speed PID loop
TM1668
- tm1668 TM1668 说明书 测试程序.rar 程序使用keil 4.0以上版本！ 例程中： 电路接法： DIO=P1^0 CLK=P1^1 STB=P1^2 VCC=5V GND=0 -tm1668 TM1668 DIO=P1^0 CLK=P1^1 STB=P1^2 VCC=5V GND=0
sx1278
- SX1278 demo 程序， 有STM32, pic驱动，51驱动-SX1278 demo procedures, STM32, pic drive, drive 51
Proteus_PWM_Boost_circuit
- proteus仿真，以LPC2138芯片为核心生成PWM波，控制升压斩波电路（PWM），实现稳定的高电压输出。包含AD转换、串口通信。-proteus simulation. This design use PWM wave generated by LPC2138 to control boost circuit and realized a steady high voltage output. ADC and serial port communication are involved i