资源列表
1
- 用51单片机控制的图形液晶的8位并口控制程序，程序调试已用在实际产品中，可以放心借鉴-MCU control with 51 8-bit parallel graphic LCD control procedures, program debugging have been used in actual products, you can rest assured that draw
2
- 51单片机的4位并行演示程序，经调试正常。-51 4-bit parallel MCU Demonstration Program, by the normal debugging.
3
- 液晶显示图形的源程序，程序调试时正常通过的，可以放心使用-LCD graphics of the source, normally adopted when debugging, you can rest assured that the use
signal_generator_heater
- 之前在学校做的两个项目。一个高压高频信号发生器，一个温控器。包含原理图和源码，希望对大家有参考价值。-Two projects I have finished in school. A high-voltage high-frequency signal generator, a temperature controller. Schematic and source code are included.Hope it useful to others.
csb
- 超声波传感器编程，测量距离在20cm外测量精准-Ultrasonic sensor programming, measuring 20cm from the outside in the precise measurement
car
- 智能小车，利用超声波传感器实现智能避障，可以实现自动行驶-Intelligent car, intelligent use of ultrasonic sensors to avoid obstacles，Can achieve automatic driving
main
- 实现温度采集控制！并实时显示温度数据，精度为1-Acquisition and Control of Temperature! And real time temperature data, an accuracy of 1
eeCONTREOLOFCOMMUNICATION
- 这是一个有关交通灯的51开发板的交通灯的引用 是转传的-ee conmmunication
STM32-USBreadSDcard-V2
- 实现通过USB接口方便的读写SD存储卡的数据和信息-Easy to achieve through the USB interface, SD memory card read and write data and information
905
- LCD字符液晶1602的初始化程序 LCD字符液晶1602的初始化程序-rgsd
msp430x41x2_adc
- //*** *** *** *** *** *** *** *** *** *** *** *** *** // MSP430x41x2 Demo - ADC10, Sample A0, Signed, Set P5.1 if A0 > 0.5*AVcc // // Descr iption: A single sample is made on A0 with SIGNED reference to AVcc. // Software sets ADC10SC to s
TimacLightV1.1
- cc2530通讯代码，可以试试看，路由器协调器可以进行通信-cc2530 communication code, you can try, the router can communicate coordinator