资源列表
time
- 基于c51的时钟，可以自主设置时间，完全源代码开放，带protues模拟程序，有兴趣的可以直接制作成成品，-C51-based clock, you can set up their own time, completely open source, with protues simulation program, are interested in can be directly made into finished products,
UCOSIIchinese
- ucos中文教程，呵呵，不知道会不会撞车-ucos English tutorials, Oh, do not know if it will crash
MCUStartApplet
- 系统板调试实现计数显示功能，利用LED动态显示电路实时显示当前计数值，计数脉冲信号由P3.3输入，计数值最大为100，溢出后清零。 -Counting system board to achieve display debugging, using real-time LED display circuit dynamically displays the current count value, counting pulse signal from the P3.3 input, counts
b843497a013b7ad7d3c331a25966c5b8
- 基于LPC2103和NRF2401的无线传输系统的发送和接收程序！编辑环境为ADS1.2-Based on the LPC2103 and NRF2401 wireless transmission system to send and receive programs! Editing environment for ADS1.2
V1
- DIY18一位数码电子时钟源程序 DIY18 a digital clock source program-DIY18 a digital clock source program DIY18一位数码电子时钟源程序
vQAR
- Virtual Quick Access Record
AT24C02
- 此程序为24c02写和读程序，基于at89s52系统，可以方便一次写入多个字节，并且可以读取实现中间任意地址读取，只需更改写和读中间从地址即可-This program is 24c02 write and read procedure, based on at89s52 system that can facilitate multiple-byte write-once, and can be read to achieve the middle of any address read, s
stepper
- 51单片机控制5804驱动芯片驱动步进电机，速度值通过spi接口（软实现）通讯存储在外部eeprom上，断电不丢失。-51 SCM control 5804 driver chip to drive a stepper motor, the speed value is through the spi interface (soft implementation) communication is stored in the external eeprom, the power is not l
SPI5045
- 单片机和5045通信，是SPI通信，程序在硬件上实现了。-5045 microcontroller and communications, is the SPI communication, the program implemented in hardware.
a
- 个人整理的关于FIR滤波器、加法器、减法器的verilog程序，供大家下载-It’s about some programs about filter，and some others I‘ll be happy if it s better for you~~~
H1
- 最简单的51系统控制小灯亮灭的控制源代码-The simplest control system 51 the control of small lights eliminate the source code
Receive
- NRF401适合于公交报站的无线射频传输源代码-NRF401 suitable for bus-stop source for wireless RF transmission