资源列表
pxa255_cpld
- 用CPLD驱动SJA1000 CAN控制器-with CPLD driven SJA1000 CAN controller
uart_example
- arm uart program lpc2104
EASY-M2416
- 嵌入式PLC,基于8051F020,在KEIL上开发,可实现自定义ＰＬＣ功能-Embedded PLC, based 8051F020 in KEIL on development can be realized from the definition of functional PLC
SMDK2410_protel_PCBlib
- SMDK2410原理图protel格式和PCB库元件-SMDK2410 diagram format Protel PCB and the components
IAPtest1
- 功能：调用IAP服务程序实现Flash ROM的读/写操作向Flash ROM地址1000H处写入10个数据，然后读出进行校验， 若校验正确，则蜂鸣器响一声-functions : IAP service program called Flash ROM read / write to the Flash ROM address 1000 H Office into 10 data, and then read out for calibration, if the calibration
lowtest1
- 功能：由KEY1键使系统进入空闲状态，由定时器0中断唤醒； 由KEY2键使系统进入掉电状态，由KEY3键盘中断唤醒-functions : bonding KEY1 by the system to enter idle state, the timer interruption awaken 0; Key KEY2 by allowing the system to enter the state of restart from the keyboard interrupt awaken
Wcstest2
- WDT功能试验。使用WDT的定时模块，实现CPU唤醒功能。 说明：CPU配置WDTE＝0、WDSE＝1/0， 将跳线器J27短接到OCA端。-Kidney function tests. Kidney regularly use the modules to achieve CPU up function. Note : CPU configuration WDTE = 0, WDSE = 1 / 0, short jumper for J27 received OCA end.
ccutest3
- 功能：使用CCU的4个模块，实现非对称PWM输出。 说明：将跳线器J5、J6、J27取出，J3短接到OCD端，在JP6的PWM1、PWM2、PWM3 分别测试模块A、B、C的输出，DAOUT是模块D输出经漏波后的电压。 通过跳线器J8、J9选择高频晶振6MHz。 -function : the use of CCU's four modules, achieving non-symmetric PWM output. Note : All of the jumpe
s3c2440_CAN_DRIVER
- s3c2440开发板can控制器sja1000驱动-s3c2440 development board can drive controller sja1000
divider3
- 一个3分频器。可进一步改装成实际需要的分频器使用-a divider. Can be further converted into actual use of the Frequency Divider
5509
- DSP509A USB的上位机驱动，一定会对大家有帮助的，-DSP509A USB PC-driven, we will certainly help,
Monolithic-machine-source-yard
- 通过软件的仿真,硬件的调试,实现串口数据的传输,开发环境包括C-C++与汇编语言.-through simulation software, hardware debugging, Serial data transmission, development environment, including C-C and assembly language.