资源列表
ARM
- 嵌入式课程设计，对大四的学生很有帮助，可以供大家参考！-Embedded curriculum design, useful for senior students, for your reference!
ucosiiitask
- stm32的ucosiii代码，实现任务的删除与创建-stm32 of ucosii code to achieve the task of creating a deleted
PDFtoWORD
- 一个PDFTOWORD的软件，就是将PDF文件转换为WORD文件-A PDFTOWORD software, PDF files is to convert WORD documents
driver_for_USB_to_serial_port
- 通用USB转串口驱动，用于串口下载程序（而现在很多主机和笔记本都没串口），这是需用到，PL2303-Universal USB-serial driver for the serial download (and now a lot of hosts and laptop no serial port), which is need to rely on, PL2303
Modbus_last
- 扩散硅压阻式智能压力传感器的上位机程序，基于最小二乘法温度补偿算法和Modbus总线协议-The proliferation of smart silicon piezoresistive pressure sensor host computer program, temperature compensation algorithm based on least-squares method and Modbus bus protocol
ARM7-LPC2000-Programlama-Klavuzu
- ARM LPC2000 Programming Guide in Turkish. ARM LPC2000 Programlama Klavuzu.
实验38 SD卡_SDIO实验
- 使用stm32f103zet6读取sd卡，并实现sd的测试工作(using stm32f103zet6 read sd to test sd. so wo can use and study sd)
ALL_model_ADC_single
- STM32F103RCT6单片机，STM32固件库v3.5，开发环境为MDK4.6，源程序点通过一个ADC通道采集-STM32F103RCT6 single-chip microcomputer, the STM32 firmware library v3.5, development environment for MDK4.6, source program points collected through an ADC channels
PMSM3_3_281x
- 这是一个基于281xDSP的三相永磁同步电机的矢量控制的源程序，解压安装后会有一个安装程序，安装后文件夹内含有全部源程序及PDF格式的程序代码模块介绍。-This is based on three-phase permanent magnet synchronous motor 281xDSP vector control of the source, extract the installation there will be a setup, installation folder and
sc2_1.3beta.tar
- c到DHL的转换工具，适合用Ｃ语言编的算法在FPGA上做加速处理．
MP3PSD
- MP3+SD卡+FATFS+LCD显示（SPI2接口）全套方案-The MP3+SD card+FATFS+LCD (SPI2 Interface) with a comprehensive plan
USB-3G-Modem-for-STM32F4xx
- 基于F4系列的USB驱动，单片机+通信模组高速率上网。(Based on F4 series USB drive, MCU + communication module high speed Internet access.)