资源列表
ra3_lib
- serial FIR filter with 2048 tap. Clock runs 4048 times faster than sampling frequency to finish FIR filter calculations before the next sample. Filter coefficients can be loaded in ROM as .hex file. Suitable for room reverberation and high order filt
driver_20130321_v3_apk_upgrade
- 三星S5VP210平台使用的敦泰电容式触摸屏驱动-Samsung S5VP210 platform uses Duitai capacitive touch screen driver
Test
- 实现了STM32对于温湿度的采集和光照信息的采集，在使用显示时，对于PCF8574T进行I2C扩展，实现LCD1602对于数值的显示(STM32 has realized the collection of temperature and humidity and the collection of light information. When using the display, the I2C is extended to the PCF8574T to realize the displ
AVR_USB_HOST
- 使用AVR芯片单纯口线实现USB HOST协议，对于节省硬件成本很有帮助-AVR chip using a simple USB HOST port line to achieve an agreement, for the helpful hardware cost savings
Frequency-meter
- 本代码包含stm32单片机与FPGA两部分，通过FPGA实现频率、时间间隔以及相位差的测量并通过spi与stm32通信，在stm32上实现数据的运算与显示。-This code contains two parts stm32 MCU and FPGA, frequency, time interval and phase measurements and by spi communication with stm32, on stm32 achieve computing and displa
SV-Tasks-a-Functions-Intro
- system Verilog tasks & functions introduction
tolern51mcu
- 单片机五一实验班设计总集。对刚接触五一单片机的人了解51单片机内核有帮助的
STM32使用I2C驱动GY-30光照传感器和SPI总线驱动DHT11
- 对于光照传感器的使用，在串口调试助手上将光照强度显示出来，每隔2S，读取一次，否则会出现读取失败。 对于温湿度传感器也是同样的道理，只是为了节省GPIO口，使用SPI单总线通信模式，实现对于温湿度的数据采集以及显示。 其中还包括了对应的串口通信，以及对于printf的重定向，使其打印在串口助手的接收区。
DSP-C-program-
- DSP的C语言编程锦集，方便大家学习，共同提高，致力于工程开发，希望对大家有帮助。-DSP-C language programming Jinji, facilitate learning and improve together, committed to project development, we want to help.
2270
- 用2270开发的传统17寸的MONITOR程序，已经调试好。-2270 development of the traditional 17-inch MONITOR program has been adjusted.
STM32F100PNVC080S
- STM32驱动OTP语音芯片NV080S。控制程序实现按键驱动和一线串口驱动NV080S。-STM32 drive OTP NV080S voice chip. Control program to realize the key driver and a line of a serial port driver NV080S.
PWM_IP_test
- zynq-7000开发板 PWM IP核（VHDL和Verilog）-zynq-7000 PWM IP