资源列表
RFID_RC522
- 基于STM32F103zet6开发板开发的RFID程序，并加载了按键触摸屏LCD显示-STM32F103zet6 development board based on RFID development program, and loaded the key touch screen LCD display
C6416-Bootloader
- 如何烧写C6416的Bootloader,已经例程。-How to program the C6416 s Bootloader, already routine.
PHILIPSARM
- 飞利浦系列ARM设计资料，包括祥光的器件封装，软件包，应用，原理图等-Philips ARM series of design information, including Yoshimitsu device package, packages, applications, schematics, etc.
temperature_sensor
- 程序基于IAR软件编写的。通过内部传感器并转化为数字信号，然后通过串口发送到PC，在PC机可以看到采样结果。估计对开发无线传感器网络的相关人士比较重要。 -Procedures prepared based on the IAR software. Through an internal sensor and converted into digital signal, and then sent through the serial port to the PC, in PC-sampli
guosai-fengji
- 2015国赛题目，完美解决方案，值得参考，主控STM32，使用空心杯完成题目，方案简单没适应性强-2015 countries title, perfect solution, it is worth reference, master STM32, use hollow cup complete subject, simple solution not adaptable
A4_Nano_Uart
- Uart串口通信程序，可以通过现在程序到开发板，成功实现和计算机的通信(Uart serial communication program, you can now through the program to the development board, the successful implementation and computer communications)
CRC16-IBM
- CRC16，16位的循环冗余校验，生成多项式为x16+x15+x2+1，一个完整的校验程序，仅供参考。-CRC16, 16-bit cyclic redundancy check generator polynomial x16+ x15+ x2+1, a complete calibration procedure for reference purposes only.
Verilog-HDL3
- VERILOG时序篇，简述了verilog设计过程中时序的相关知识。-VERILOG precursor, this paper expounds the relevant knowledge of VERILOG design process sequence.
FIFOidle
- 基于STM32，以软件，利用空闲位实现USARTFIFO-Idle bit implementation USARTFIFO
I2C_L3G4200D_TEST_OK
- STM32与L3G4200D陀螺仪的测试程序，I2C接口。-STM32 and L3G4200D, gyroscope test program, I2C interface.
RFID_RC522
- RFID_RC522 STM32程序（不错的程序。。）-RFID_RC522 STM32
61IC_S4475
- TI电动机的DSP控制（第2版）随书光盘 TI公司文件子目录-TI DSP motor control (2nd Edition) CD with the book TI' s file subdirectory