资源列表
CODE
- 这是DSP2812的一些基本的代码，包括LCD,CAN总线，电机驱动，AD转换等，对于初学者有很好的参考价值。-This is the DSP2812 some basic code, including LCD, CAN bus, motor drive, the AD conversion, a good reference for beginners.
PWM_Output
- 基于STM32 的上输出PWM波的代码，非常管用-based on STM32
dsp
- dsp信号处理器教学课件，共九章。dsp信号处理器教学课件，共九章-dsp DSP courseware, a total of nine chapters. dsp DSP courseware, a total of nine chapters
RS_422
- 在K7FPGA上利用verilog语言编写的RS422串口，由于没找到Verilog所以选择了VHDL(On the K7FPGA, using Verilog language RS422 serial port, because did not find Verilog, so chose VHDL)
DC_MOTOR -balance - 副本 - 副本
- 基于STM32步进电机平衡小车代码，自己写的代码(Step motor balancing car code)
RSCode_XuChaojun
- 徐朝军的博士论文，详细的介绍了RS编码解码算法以及进行了性能分析。-Doctor paper from Xu Chaojun . A detailed descr iption of RS encoding and decoding algorithms and performance analysis
STM32_DRV8711
- STM32 步进电机控制 德州 DRV8711、电路原理图cadence- STM32 stepper motor control TI DRV8711, circuit schematic
Nios_Timer_DS1337
- 利用带有I2C总线接口的日历时钟芯片DS1337，在NIOS II嵌入式系统平台上实现一个实时时钟，并可在显示器上显示出预置的时分秒。硬件平台为Altera的Cyclone II版Nios II开发环境
AESEncryptionDecryption
- Program for implementing AES on 8051 based microcontrollers. SDCC is used as the C compiler. Microcontroller used is P89V51RD2. There are 2 programs included. One program will accept string via UART and accept key via a 4x4 keypad and display decrypt
A0
- 工业控制模块，输出模拟信号，通过485总线广播到上位控制器进行现场控制-Industrial control module, the output analog signal, broadcast via the 485 bus to the host controller, on-site control
stm32_DMX512
- STM32DMX512数据发送程序，可供STM32开发只用。采用标准的DMX512格式发送。 STM32DMX512 data transmission program, for the development of STM32 only. Adopting the standard DMX512 format.