资源列表
16pam
- 用VERILOG语言实现16QAM的数字调制的程序-With the VERILOG language 16QAM digital modulation procedures
FPGA
- 文中详细介绍了关于FPGA的相关内容和入门要领，便于读者学习和进行综合提高-Text in detail on the FPGA and the associated key entry for the reader a comprehensive study and improve the
无创血压、血氧、温度、皮电测量单片机程序
- 无创血压、血氧、温度、皮电测量单片机程序 使用uVision编程的下位机程序 能够在显示屏上显示(Non-invasive blood pressure, blood oxygen, temperature, skin electrical measurement of single-chip microcomputer program using uVision program can be displayed on the display screen)
temperature-collect
- 基于NRF模块，DS18B20的温度采集组网代码-the code of temperature collect ,base on NRF module and DS18B20 sensor
uCOS-III-for-VC
- UCOS VC6.0 支持浮点 完全可以使用 有代码解释-UCOS VC6.0 support floating-point can use the code to explain
20110915
- 利用红外遥控器发出的正转、反转、停止信号，与窗帘相连接的控制电路相接收，从而达到远距离对窗帘的打开、闭合、和停止。遥控器设有4个按键，打开、关闭、停止、手动。这样我们就可以避免马达收到信号后一直运行。我们也可以让窗帘停止在任意位置，最大可能地降低遥控器和接收器的功耗。 at89s51 -Infrared remote control issued by the forward, reverse, stop signal, and the curtain control circuit c
arm_shaangu_v16
- 校准模拟量通道 添加TCP/IP协议版 添加傅立叶变换板 添加启动录波 添加故障录波 SCADA通信 二次谐波分析 处理直流信号 PID调节模块 -Calibrate the analog channel to add TCP/IP protocol version of the Fourier transform plate add add add fault recorder starts recording wave analysis of second harmonic SCADA
Verilog-Niosii-TLC1549
- niosii的一个完整的工程 Q2 软件是9.1版本，里面做了一个TLC1549的AD转换串转并的模块-niosii project with a TLC1549 module
10_ImageEdge
- 基于System Generator的图像处理工程,多媒体处理FPGA实现的源码,图像边缘提取-System Generator based image processing engineering, multimedia processing FPGA implementation source code, image edge extraction
programme
- 这是我买的开发板的配套基础例程，里面很全面的运用了2812的各个模块来实现他们的功能-This is what I bought routine development board supporting infrastructure, which is very comprehensive use of 2812 to implement the various modules of their function
LCD12864
- 液晶显示程序，源码，可以参考一下，如果有需要的话。如果有错误的地方还请指正(LCD program, source code, you can refer to, if necessary. If there is a mistake, please correct me)
2131gui
- uc/gui在ARM中的移植，程序调试通过！-uc/gui in the ARM in the transplant program debugging through!