资源列表
cvavr
- avr codevision software for free download
iP2200_Linux_260.tar
- 佳能打印机IP2200在Linux下的驱动。
迷你四轴工具包
- MWC四轴飞控源程序及调试工具,使用说明等(MWC four axis flight control source program and debugging tools, instructions and so on)
icnado_newgood_pinlvji
- 使用ISE编译的频率计,可测最低频率范围1hz,最高根据系统时钟决定-ISE compiled using the frequency meter, the lowest measurable frequency range 1hz, the highest decision according to the system clock
u-boot-imx.tar
- uboot,支持imx233、imx28,支持从SPI、nand启动-uboot, support imx233, imx28, support from the SPI, nand start
Waveletsignalprocessingtoguide
- 信号处理的小波引导对于学习用小波分析进行信号处理的学者非常有用-Wavelet signal processing to guide for learning signal processing using wavelet analysis is very useful for scholars
Pico_2.9.4.11Hd_build_18.09.09_blacktip_upgrader.
- 2.9.4.11hd version gtm-382 firmware upgrade tool
e2prom_rd
- 该verilog代码用于E2PROM操作运用,用于I2C时序操作,存储数据-Operation is applied, the verilog code used in the E2PROM chips was introduced for I2C timing operation and store data
stm32-bldc
- 基于stm32 的直流无刷电机驱动程序,BLDC 三相直流无刷电机,无霍尔传感器,速度PID环-Based stm32 DC brushless motor driver, BLDC phase DC brushless motor without Hall sensors, speed PID loop
stm32-transplantation
- 基于mwc的飞控及传感器全套代码stm32移植(硬i2c+传感器自测)-Flight control and sensor based on non full code stm32 transplantation (hard i2c+ sensor self-test)
danpianji
- 该程序包含了大量的关于单片机编程的实例,对于初学者来说,非常有借鉴的价值!-The program contains a number of examples on microcontroller programming for beginners, learn the value of
ucos292_MSP430F149
- 在MSP430F149上移植了ucos292。个人感觉,ucos 2.92版比2.52版所占空间更小,推荐使用。 -In the MSP430F149 on a transplant ucos292. Personal feeling ucos 2.92 version is smaller than the 2.52 version of the space occupied, it is recommended to use.