资源列表
5045
- 5045复位芯片程序,目前多数单片机使用此芯片复位,我想搞开发的需要此代码的.
24C04
- Atmel 24c04 eeprom 读写程序，Keil_C51
用普通IO模拟串口(asm)
- 普通IO口模拟RS232串口 占用定时器0中断 在TH0,TL0中设置波特率的大小 注意不要开定时器0的中断，这里用的是查询方式-ordinary RS232 serial I simulated occupancy Timer 0 interrupt the switching, TL0 set baud rate to the size not to open the Timer 0 interrupt here with the inquiry
tlc549
- tlc549A/D转换，电位器调整得到一个0-5V的电压，A/D转换后，利用数码管显示，精确到小数点后两位-tlc549A/D conversion, to get a potentiometer to adjust the voltage 0-5V, A/D conversion, the use of digital display, accurate to two decimal places
vk
- 51单片机串口只有一个，本程序是利用vk芯片进行扩展的实例，扩展为3个串口。-51 Single-chip serial port is only one, this procedure is to expand the use of vk chip example, extending for three serial port.
TASK_165
- 利用C8051F020作为控制器，对74LS165进行控制-C8051F020 use as a controller, control of the 74LS165
2430TC77
- CC2430 带TC77源程序 方便移殖到任意单片机使用-CC2430 with TC77 transplant source to any single-chip to facilitate the use of
EX_PWM
- pj working with a compiler
18B20
- 18B20+LED+控制二极管的亮灭，供温控系统设计者使用，已经在开发板上使用过，放心下载-18B20+ LED+ diode light off control for the temperature control system designer to use, has been used in the development board, secure download
01
- 基于单片机的1415发射机，1602显示发送的频率-Transmitter based on single chip 1415, 1602 shows the frequency of sending
ad_led
- 二线传输 单片机代码 很重要的 可以进行测温 -Wire transfer microcontroller code can be very important temperature
LED_KEY
- P1.1-P1.4为列线,P1.4-P1.7为行线矩阵键盘数码管显示键值-P1.1-P1.4 as a column line, P1.4-P1.7 as a line of line matrix LED display key keyboard