资源列表
AVRBoot_M8
- atmega8的BootLoad程序,需写入M8之中,现已在Atmega8芯片上测试通过。我已使用它做了几个项目,除第一次使用下载线,以后写片子只用串口线.-atmega8 BootLoad the procedures required to be included in M8, which is available at Atmega8 chip test. I have to use it to do several projects, in addition to the first u
13898356CAN_TEST
- usbcan的人机交互编程vc例程,嵌入式可以参考。
motorPWM
- 用C语言编写的驱动电机的程序 调试通过的 直接可以用 51环境-Using C language debugging drive motor can be used directly through the 51 environmental
bit
- 可实现对凌阳spce061a进行单个管脚进行操作的头文件,本人已在lcd1602的控制中使用过-Sunplus spce061a can be realized on a single pin to operate the first paper, I have been in control of lcd1602 used
ds18b20
- 基于MCS-51的温度测量程序 温度程序-MCS-51 based on the temperature measurement procedure
dianzizhong
- 电子钟 基于单片机的课程设计的程序 通过编译软件和烧写软件来实现与单片机上- Electric clock Based on SCM curriculum design program compiled by software and burning software to realize and MCU
24c02
- 有关51单片机读写AT24C02的C语言程序,需要的下-For read and write AT24C02 MCU 51 of the C language program, required under the
JIAN
- 单片机的时钟程序。可以实现四位数码管的时分秒的显示。-MCU clock program. Can be achieved when four digital tube display minutes and seconds.
Hardware
- Hardware driver for LCD
dingshiqi
- 89c52定时器的应用,利用定时器t0工作方式0.-89c52 timer application work using timer t0 0.
wendu
- 基于51单片机开发的DS18B20温度传感器和数码管的程序,硬件连好可以直接用-DS18B20 temperature sensor based on 51 single-chip development, and digital control program, the hardware is connected directly
png2cur_src
- Part of Libnodave, a free communication libray for Siemens S7 200/300/400 via the MPI adapter 6ES7 972-0CA22-0XAC or MPI adapter 6ES7 972-0CA23-0XAC or TS adapter 6ES7 972-0CA33-0XAC or MPI adapter 6ES7 972-0CA11-0XAC, IBH/MHJ-NetLink