资源列表
mul_unsign123
- P18F4610的有符号16*16运算C结合汇编．很好的学习例子．MCC18编译器．-P18F4610 symbols of 16 * 16 C combined operations compilation. A good example of learning. MCC18 compiler.
isd4003C
- 可录放语音芯片ISD4003的放音驱动程序，是本人精心调试的结果，与大家分享-can chip ISD4003 voice recording and showing the audio driver, I was careful testing results share with you
eye1
- AT89C52单片机上运行的程序,文件名为eye1.c 功能：AT89C52单片机作为分站与上位机（PC机或工控机）通讯， 双方均有RS485接口 ，T1作波特率发生器, 波特率为1200， 与上位机通讯的主要流程为：中断接受上位机发来的地址 信息，看是否是给本站发来的，若是, 接受后续的15个字 节，然后发送43个字节。若不是, 则不予理睬。 配套上 位机程序为xsa2.c。
TestGUI
- 利用窗体完成简单的四则运算,并输出结果.-Use the form to complete simple arithmetic, and output.
usart
- 实现ATMEL128 串口之间的通信-enable communication between ATMEL128
i2c
- 基于单片机C8051的i2c接口读写程序-i2c interface code based on c8051
AD7541_SIN
- AD7541产生sin.c 8位DA转换 并入 幅度可调，1000HZ -AD7541 generates sin.c 8-bit DA converter incorporated adjustable amplitude, 1000HZ
chepin
- 利用51单片机进行测频，分为测频与测周两种方案。10Hz到10KHz范围-Carried out using 51 single-chip frequency measurement, frequency measurement and the measurement is divided into the two-week program. Range of 10Hz to 10KHz
NRF_TO-HUMAN
- 基于arduino以及无线模块NRF24L01的无线监控程序 使用了人体红外探测模块检测-Based on the arduino as well as wireless module NRF24L01, wireless monitoring and control procedures using infrared detection module detects
16F-EXTERNAL--INT
- Code for External Interrupt
LCD16x2 Interfacing
- This source VHDL code is used for control LCD16x2 on FPGA
lcd
- This source is used to control LCD 16x2 on FPGA board