资源列表
1602
- 本程序实现1602的简单显示控制
x9c103
- 本程序是基于51单片机的数字电位器的衰减，将三个数字电位器串着集连，可以步进一万份！-This procedure is based on 51 single-chip digital potentiometer decay, the three sets of string digital potentiometer connected, you can step ten thousand copies!
I2Ctest2
- 利用单片机I2C资源口（SCL、SDA）写的I2C读写程序，在硬件上经过测试 本例基于单片机型号为PIC18F4620-Single-chip I2C port utilization of resources (SCL, SDA) to read and write I2C write procedure, tested on hardware in this case models based on single chip PIC18F4620
89s52_serl
- 基于89s52的c51串口通信源程序 串口的4种工作方式对应着三种波特率模式： 对于工作在方式1和方式3，波特率由定时器/计数器1T1的溢出率和SMOD（PCON（电源控制寄存器）D7位）决定，-Based on the C51 serial communication 89s52 source of the four kinds of serial work corresponds to the baud rate of three modes: Mode 1 for the w
LPC936_DA
- 学习一下LPC936的DA转换问题? 有用到LPC900的AD、DA即可-lpc936 ad
X2504345
- One for the external microcontroller to see the door x2502345 c-language program-A BCD conversion software for the microcontroller, 16-hex BCD conversion software
yejing1602xianshi
- 液晶1602显示，描述:该程序实现了对液晶1602的控制。-Liquid crystal display 1602, Descr iption: This program implements the control of the LCD 1602.
isd4004lufangyin
- 此源代码为isd4004分段录放音的程序，并由51单片机所控制-The source code for isd4004 sound recording program segments, controlled by the microcontroller 51
asmled
- 用外部中断控制P1口外接8只灯闪烁。要求：P1口外接8只灯作左移循环点亮，当外中断发生时，作交叉闪烁4次后再左右闪动4次后回到循环左移点亮状态-P1 port interrupt control with external add-eight light flashes. Requirements: P1 port for external 8 lamps light up the left loop, when the external interrupt occurs, for cross
luoyangcoffee
- AVR MEG8单片机串口接收到字符串 判断正确后 再发送相应的字符串-AVR MEG8 microcontroller to determine the correct serial port receives a string and then send the appropriate string
dn_timer
- DECnet Socket Timer Functions for Linux v2.13.6.
uartlite_double
- 基于ZYNQ开发平台VIVADO开发环境调用PL双UART_LITE源程序-Based on the ZYNQ development platform VIVADO development environment Call PL double UART_LITE source