资源列表
c51crc
- 51系列单片机CRC校验程序-51 series monolithic integrated circuit CRC check routine
shumazhongxianshi
- 数码时钟显示，用8位LED软件译码动态显示，P0为字段码,P2为位选码，数码管共阳， key0为位选键；key1为加“1键；key2为减“1”键。-Digital clock display with 8 LED dynamic display software decoding, P0 code for the field, P2 election code for the digital, digital tube were positive, key0 bond election fo
pwm
- S3C2440,ARM-Linux下的PWM测试代码-S3C2440, ARM-Linux code under the PWM test
flash1
- c8051f的 flash读写 端口初始化 中断 晶振选择-c8051f flash read
80S51shumaguan
- 80S51单片机控制的数码管动态显示-80S51 Microcontroller digital dynamic display 00000000
chapter06-lab
- 嵌入式实验，中断 ISR，开发环境，Tornado ，风河公司-Embedded test, interrupt ISR, development environment, Tornado, Wind River
51_test-frequency
- 首先要把51hei单片机开发板上的ne555的方波输出信号J7的第一脚用杜邦线,引入P3.2口,数码管即可显示ne555震荡电路当前的频率值,旋动PR1电位器可发现数字有变化. 原理：1秒钟内计数外部脉冲个数，如计数1000次，则表示频率为1000Hz -First, we should 51hei microcontroller development board ne555 square wave output signal with the first pin of J7 DuPo
6416
- 4个字的LED显示程序，由595级联输出显示-The four-character LED display program, 595 cascade output
1.8寸tft简单显示
- ST7735驱动IC,1.8寸tft简单显示-The ST7735 driver IC, 1.8 inch tft simple display
fm25cl64
- stm32f103 读写铁电函数（fm25cl64）-stm32f103 read and write the ferroelectric function (fm25cl64)
wave
- STC单片机的串口和定时器同时使用,主要注意的就是不要重复的对TMOD寄存器赋值-STC microcontroller serial port and timer simultaneously
AVR_GY-30
- 基于单片机AVR的光照传感器 并用1602进行实时显示光照强度-And real-time display with 1602-based microcontroller AVR illumination light sensor