资源列表
44keyboard
- 4*4键盘C51单片机程序.本程序已经调试通过，4*4键盘接P1口数据从P2的8个发光二极管来表示
init_ILI9325_cmo
- 2.4/2.8CMO+9328液晶初始化代码，已测试OK，欢迎大家试用-2.4/2.8CMO+9328 LCD initialization code has been tested OK, welcome trial
TXRC
- 基于Pic16f1974 的 RS485-modbus 协议转换 -Pic16f1974 the RS485-modbus connection-based protocol conversion
ps2_test
- 鼠标文件读取测试通过读取/dev下的mouse文件，返回鼠标信息的四个字节-PS/2 mouse
blink
- 用DALLAS公司的DS89C420单片机编写的汇编语言程序-DALLAS companies with the preparation of single-chip DS89C420 assembler language program
DS18B20gai
- 实现对DS18B20的读取,注意：单总线协议对延时要求比较严格，此程序中采用的是11.0592M的晶振，如果使用其他的晶振请跟据DS18B20的资料修改延时参数 -DS18B20 achieve the right read, attention : single bus protocol to delay more stringent requirements, This procedure is used in the M 11.0592 Crystal Oscillator, If y
eeprom
- eeprom在51中的读写c代码，已测试通过，可以直接下载使用-eeprom read and write in 51 of the c code, have been tested, you can directly download
rxremote
- this program is very useful for many people
state_machine
- 状态机控制步进电机 配套开发板型号:A-C8V4-Stepper motor control state machine model supporting the development board: A-C8V4
prbs
- 伪二进制随机码的产生，在fpga上已经验证-Pseudo-random binary code generation
fifo
- 同步fifo，使用ISE13.4 V5器件 速度550MHz-Synchronous fifo, use ISE13.4 V5 device speed 550MHz
L3G4200D_SPI_FOR_Arduino
- 本程序基于Arduino UNO开发，代码通过SPI接口读取L3G4200D陀螺仪的Y轴角速率-This program is based on Arduino UNO. This program read Y-axis rate L3G4200D Gyro through SPI interface.