资源列表
UART
- 此程序是用msp430g2553通过串口与上位机通信，-This program is to communicate with the host computer through the serial port using msp430g2553
Flashwriten-and-read
- 此程序是对msp430g2553flash的读和写程序，使得430的大量存储空间可以得到应用-This program is read and write to msp430g2553flash
main
- 利用msp430f149的SPI功能来控制程控放大器PGA112的程序-Use msp430f149 the SPI functions to control the procedures of the programmable amplifier PGA112
bainpinshuchujiuhushengyin
- 51单片机的变频声救护车报警信号输出试验，单片机教程：http://www.ipbb.cn，主要利用５１单片机的定时器输出控制蜂鸣器，发出救护车报警信号！-Variable frequency sound of an ambulance alarm signal output test, 51 single-chip microcontroller tutorial: http://www.ipbb.cn, the main use of the 51 single-chip timer out
love
- 实现单片机发光二级管点阵动态显示英文“我爱你”三个字。-Led dot matrix dynamic display "I love you".
ads7813
- TI\BB公司的ADS7813 16bit A/D转换器的驱动程序。IAR C环境，AVR At90s4414单片机。-TI\BB ADS7813 16bit A/D Convertor drivers in IAR C. Use AT90S4414/8515 MCU.
float_to_hex_C
- 单精度浮点数转换成十六进制数 单片机用 非常简洁和实用，欢迎下载-float convert to hex program
io
- 控制步进电机。用于51单片控制步进电机正反及调速。-51控制步进电机。用于51单片控制步进电机正反及调速。
main
- 使用MSP430G2553单片机切换到高频晶体振荡器！-To switch to the high-frequency crystal oscillator use MSP430G2553 MCU!
ha0009s
- HT48 & HT46 MCU IO接口的应用-流水灯-HT48 & HT46 MCU IO interface- light water
distance_3
- 基于KEILC软件和89C51单片机的程序，用于超声波测距模块。-For ultrasonic ranging module KEILC software and 89C51 microcontroller-based programs.
usart
- pic单片机16f877a的串口调试c转换程序。。已经测验过-pic microcontroller 16f877a the serial debugging c conversion program. . Already quiz. .