资源列表
key_check
- 用于检测非自锁的按键,可以识别按键是否按下、长按、释放等
CTK-Y07
- C语言编程 嵌入式开发语言 单片机开发语言 是C语言-OK LAUGUE GOOGLE
ads1100
- ads1100,16位模数转换芯片,i2c接口-ads1100, 16-bit analog-digital converter chip, i2c interface
main
- it is the source code written in C ,which may make a great contribution to your study about ARM.
AVRdriver
- 时代变了,软驱没有用了,但是里面的电机是比较好玩的,拿出来研究研究。时代变了,软驱没有用了,但是里面的电机是比较好玩的,拿出来研究研究。-Times have changed, do not use floppy, but the motor inside is more fun, out through that. Times have changed, do not use floppy, but the motor inside is more fun, out through that.
lesson9
- 用1602做的可调时钟程序,用一个独立按键按多次控制调节的位置,用另一个按键控制加调节,再用一个键控制减调节-Adjustable clock to do with the 1602 program, with a separate control button repeatedly adjust the position by using the other buttons control the regulated, then a key to control by regulation
atmega16-123456
- atmega16处理器编程用c代码,可以作为入门者初学,很不多的-atmega16 processor is programmed with c code, can be used as beginners beginner, very much
PIC16F676_AD
- PIC16F676 用于感烟探测器中的AD采样程序。两次采样,后次减前次即为采样值-PIC16F676 for smoke detectors in the AD sampling procedures. Two samples, after the meeting by the previous sampling value is
8259.asm
- 直接用手动产生单脉冲作为中断请求信号。 要求每按一次开关产生一次中断,在屏幕上 显示一次“TPCA Interrupt!”,中断10次后 程序退出-Directly by hand to produce a single pulse as an interrupt request signal. Each time you press the switch requires an interrupt is generated, show a TPCA Interrupt! On the sc
STM8-I2C-Driver
- STM8S103F3 I2C硬件从机驱动程序-STM8 I2C Driver
mcp3201
- c code to interface adc3201 with 8051
Dig_Temp
- Using ds1620 whitch is temperature sensor, The temperature is displayed on TEXT LCD.