资源列表
200731311152164420
- PIC点亮LED灯的源程序2,C语言点亮RC0口的LED-PIC lit LED lights of the source 2, C language RC0 I lit LED
shuzizhong
- 我上传的一些单片机的资料，数字钟的实验程序，希望对大家有帮助
LCD_C
- lcd 与C51 的驱动程序 1、本实验箱采用的液晶显示屏内置控制器为SED1520，点阵为122x32，由两片SED1520组成，由E1、E2分别选通，控制显示屏的左右两半屏。-LCD C51 and a driver, the use of experimental boxes LCD screen embedded controller for SED1520, to 122x32 dot matrix, composed of two SED1520, E1, E2 respective
7.21
- 交通灯控制程序，实现四个路口循环控制，并有倒计时显示-Traffic lights control procedures, the realization of the four junctions cycle control, and the countdown show
PIDarithmetic-Inc_RClowpass
- 适用于半导体制冷恒温槽产品，已成功用于实验室常备装置-Applicable to semiconductor refrigeration thermostat bath products, has been successfully used in the laboratory standing device
LPC1114
- this a Header to use wiyh the NCP LPC1114 microchip.-this is a Header to use wiyh the NCP LPC1114 microchip.
monichuankou
- 将单片机IO口模拟为串口发送数据，51单片机可直接编译后使用（若出现错码可适当降低波特率）-The single-chip analog to serial IO port to send data, the microcontroller 51 can be directly compiled using (error code if there may be appropriate to reduce the baud rate)
stm32f10x_crc
- stm32程序初始化部分c语言部分源码，主要还是串口部分-some program of stm32
VHDLSourceProgramofReadDAatasFromSRAM
- 从SRAM中读取数据并显示的VHDL源程序，了解串口通信的基本原理，了解VGA现实图像的方法和原理。-VHDL Sorce Program of Read Datas From SRAM
pinglu(0.1-25.5KHz)
- 这是用于测量另一个单片机发出的信号的频率，只是在低频的测量，-This is the one used to measure the frequency of SCM signals only in the low-frequency measurements,
32bitCLA
- a carry look ahead adder
shift-register
- FPGA/CPLD 的verilog移位寄存器代码。-verilog shift register code.