资源列表
write-read
- vxWorks下的读写程序-write procedures
Content_Addressable_Memory
- Content Addressable Memory 的verilog源代码。经过modelsim仿真。
HDB3
- 用verilog HDL语言，通过一个4位移位寄存器实现一个信号转化为HDB3码并进行测试 -Using verilog HDL language, through a 4-bit shift register realization of a signal into HDB3 code and test
counter
- Decimal counter which is counting from 256 to 0. After that there will appear logic "1" in out. You can stop counting by pressing sequence. I called it detonation clock :]
doorlock
- 门锁电路的检测器，可以预先输入密码，当输入数值和密码相同时有灯闪亮显示正确。本程序只有一个文件-Lock detector circuit that can pre-enter the password, the password input the same values and have lights shining display correctly. This procedure is only one file
lms
- 本文主要介绍了关于智能天线中的lms算法并进行了仿真-This paper introduces the smart antenna lms algorithm and simulation
12864serial-communication
- 此代码为51单片机12864串行通信显示代码，经过验证切实可行。-This code for the 51 single-chip microcomputer 12864 serial communication display code, proven feasible.
ADDA
- 使用c8051f020单片机定时器3溢出中断实现的 AD/DA转换，-c8051f020 AD/DA
1602show-experiment
- 1602显示实验，第一行显示I LIKE MCU，第二行显示QQ 12345678，延时函数，命令子函数，数据子函数，初始函数-1602 experiment, the first line shows I LIKE MCU, the second line shows QQ 12345678, delay functions, commands Functions, Data Functions, initial function
RS232-communication-source-code
- 上位机通讯处理程序，C语言编写，包括识别主机地址，CRC校验等。-The host computer communication procedures, C language, including the identification of host address, CRC parity.
set-Timer
- 对一些寄存器进行了初始化设置，并设置好定时器，定时结束后，跳转中断程序-set Timer
74HC595_stm32
- 74HC595驱动 74HC595驱动-74HC595 driver