资源列表
51_PWM
- 基于51单片机，使用PWM对LED灯进行调光-Based on 51 single-chip, using the PWM dimming of the LED light
key
- 基于c8051f020矩阵键盘，用过的程序，很好用-Based on c8051f020 matrix keyboard, used programs, easy to use
COLOR
- 8寸工业彩色显示器640*480并口测试-Industrial 8-inch color display 640* 480 parallel test
CEPIN
- mcu51测频率。自己编程通过测试。能够方便移植到其他应用中-measure frequency using mcu51
Traffic-Light
- 十字路口交通灯 如果一个单位时间为1秒，这里设定的十字路口交通灯按如下方式四个步骤循环工作-Crossing the traffic lights If a unit time for 1 second, here the crossroads of the traffic lights set according to the following ways four steps circulation work
2
- 东软嵌入式高级C培训(2007))，看了就知道了，很多提高程序效率的方法，和调试的技巧都很经典实用。-Neusoft Senior C Embedded Training (2007)), read to know, a lot of ways to improve program efficiency, and debugging skills are very classic and practical.
ATmega16-generate-sine-wave-source
- ATmega16 产生正弦波 源程序-ATmega16 generate sine wave source
timer
- 在使用12MHz晶振的条件下，由8051内部定时器1按方式1工作，即作为16位定时器使用，每0.05秒钟T1溢出中断一次。P1口的P1.0～P1.7分别接发光二极管的L1～L8。（用连线连接J2、J3）。 要求：编写程序模拟一循环彩灯。彩灯变化花样为：①L1、L2、…L8依次点亮；②L1、L2、…L8依次熄灭；③L1、L2、…L8全亮、全灭。各时序间隔为0.5秒。让发光二极管按以上规律循环显示下去。 编写一个救护车警笛声程序，要求：高低两种音调交替出现，交替周期1～1.5S。-Condi
jieshou
- 单片机双击通信接收代码，将传送过来的数字显示在七段数码管上，并且实时将主机发过来的数字如温度显示出来-SCM double-communications receiver code will be sent over the digital display on the 7-segment digital tube, and real-time host sent me digital temperature display
NTC_TEMP
- 对NTC电阻进行查表测温，并对两点之间的温度进行平均运算。是学习电阻测温最好的C程序。-NTC resistor for temperature measurement on the look-up table, and the average temperature of between two operations. Resistance temperature is to learn the best C program.
main
- 主程序等待外部中断触发的噪声报警，LED显示运行状态-Main program wait for an external interrupt trigger noise alarm, LED display operating status
Text1
- 给遥控解码，在十米之内，只要有红外线感应，就能读出码.-To the remote control decoder, within the ten meters, as long as there are infrared sensors, knows the code.