资源列表
TEST
- MCS-51单片机的定时器使用的汇编程序-MCS-51 microcontroller timer using assembler
key
- 介绍了4*4键盘的单片机软件开发，并给出了范例。-Introduced a 4* 4 keyboard microcontroller software development, and gives an example.
dingshiqi
- c8051f410 定时器中断定义与使用-c8051f410 definition and use the timer interrupt
c8051PCAcapture
- c8051,PCA捕捉模块0的CEX0被设置在按键S3对应的引脚上，按下和松开S3，将会产生下降和上升沿信号，引发捕捉模块动作。-c8051, PCA Capture Module 0 CEX0 S3 is set the corresponding pin in the key, press and release the S3, will result in decline and the rising edge signal capture module trigger action.
Slave
- canopen协议栈源程序，学习can总线的绝佳资料，值得学习-canopen protocol stack source, can learn a great bus information, it is worth learning
PIC16f877-keyboard-scanning-
- 该文件为PIC16f877键盘扫描程序,保证是源码，而且可靠。-The file is PIC16f877 keyboard scanning procedures to ensure that source, and reliable.
nixie-tube
- 数码管前三位显示一个跑表，从000到999之间以1 秒速度运行，当按下一个独立键盘时跑表停止，松开手后跑表继续运行。(用定时器设计表)-the function about nixie tube
shizhong
- 时钟电路的C语言程序，与单片机连接正常显示，这是我们实训的程序保证能用-Clock circuit C language program, normally connected with the microcontroller shown, this is our training program guaranteed to
main
- 51单片机的数码管动态扫描，用C语言编写，可以设置时间。-51 MCU digital dynamic scanning, using C language, you can set the time.
ServoCon
- 一段关于舵机的控制程序，可以控制舵机的启动停止-failed to translate
motor
- 本段 程 序是关于介绍关于步进电机的程序-This section of the program is a program for presentation of the stepper motor
Uart0
- 基于MSP430F149单片机的串口0驱动程序-MSP430F149 microcontroller-based serial port 0 driver