资源列表
24c02
- 以i2c总线串行方式读取24c02数据的源码
ADC0808
- 单片机AT89C51和ADC0808组成的模数转换程序
SlopAD
- MSP430F413的SlopAD代码，对新手非常有帮助
5
- 四位数码管显示 没1分钟进1位 是通过最原始的51单片机来实现的
SAVRP
- 该算法经运行，无任何问题，可用于解决模拟退货算法求解车辆路线问题-The algorithm by running without any problems, can be used to solve the simulation algorithm Return Vehicle Routing Problem
16f630PWM
- 本程序是采用改变PWM波脉宽方式实现调光，改变输出的硬件电路也可用于其他功能。-This procedure is used to change the PWM pulse width wave dimming means to change the output of the hardware circuit can also be used for other functions.
I2ctongyong
- 一个用Keil C写的，用C51单片机模拟I2c标准的通用的启动、停止、读、写程序-A written using Keil C, with a C51 microcontroller' s general-purpose analog I2c standard start, stop, reading, writing process
AD_DA
- 基于AT89S52单片机的AD和DA连调程序，AD使用ADC0832,DA使用TLC5615,调整DA可以改变灯的亮度，并改变AD的采样值。-AT89S52 Microcontroller based on AD and DA with transfer procedures, AD using the ADC0832, DA use TLC5615, DA can be changed to adjust the brightness of light, and change the valu
demoSTEP
- 这是一个使用单片机通过NUL2003驱动步进电机程序. 步进电机: 5伏,500MA/STEP,四限四拍. 将步进电机的A B C D四个绕组连接到 S51E板"步进电机"的A,B,C,D,将公用抽头并接在VCC上. 将"控制输入口"的A B C D 接焊盘 P2.3,P2.2,P2.1,P2.0. 将P2.3-P2.0跳帽置焊盘位. -english
temperature-measurement
- 在visual C++环境中的温度调节设计 用于proteus的设计中。-In visual C++ environment, temperature regulation is designed to proteus design.
ds18b20
- DS18B20温度检测程序，在CVAVR下可以正确运行-DS18B20 Temperature Detection，which runs normally in CVAVR
LED
- HL1606S LED灯条控制器控制程序-HL1606S LED light bar controller control program