资源列表
AD421
- 本程序为AD421的开发源代码，进行单片机研发之用，将16为串行数据转换为模拟数据-The program source code for the development of AD421, the microcontroller development purposes, will be 16 for the serial data is converted to analog data
4LQDQ
- 用C语言写的4路抢答器,对单片机入门者可能会有帮助.-Using C language Answer the 4-way, and on the single chip may be helpful to beginners.
decoderesp
- GA3 for single machin problem
1
- 实现时钟程序，要求开始时DS1、DS2显示分钟，DS2的小数点亮，DS3、DS4显示秒，初始时都显示0；运行后DS4每隔一秒钟数字加1，加到10后变为0，DS3加1，DS3、DS4加到60后变为00，DS2加1；DS1、DS2加到60后，切换到小时状态：DS1、DS2显示小时，DS2的小数点亮，DS3、DS4显示分钟，DS4的小数点亮每隔一秒亮灭一次，亮灭分别30次后，DS4加1。-Realization clock procedure, request beginning hour DS1,
TLC1543
- 8051与TL1543构成的数据采集A/D的试验电路-8051 and TL1543 composition data acquisition A/D Test Circuit
compass
- HMC6253 interfacing with atmega
less5_5.2
- 中断数码管秒表计时!和独立键盘！ 分别有开始键 停止键 复位键-Digital stopwatch timer interrupt control! And independent keyboard! Respectively the Start button stop button reset button
matrix_keypad
- this controls a 4x4 keypad for avr microcontrollers. simple to use
main
- /*** *** *** *** *** *** *** *** *** *** *** *** *** * Platform: PIC1687A Project : 实验3：单个按键控制LED闪灭 Clock F : 外部4M Software: PICC Author : comments: 学习使用单个按键控制LED的闪灭 PIC里面只有B口设置了上拉电阻， 用的时候必须用编程打开它，（OPTION=0X7F） 其他端口都须自已连上拉电阻， 一
7se_stopwatch
- 7 segment stop watch,for c51 controller. with two switches for star and to stop. using timer
cm_sm34
- 根据蒙特卡罗分析原理，QPSK及QDPSK误码率仿真-According to the principle of Monte Carlo analysis, QPSK and QDPSK BER simulation
SARAB
- MATLAB FOR BUSINESS AND STUDENT