资源列表
STC_EEP
- Stc EEP单字节编程 c代码 可以直接扩展到整型等变量应用-stc mcu eep
keil
- 4*4的矩阵键盘，在51单片机开发板上调试成功，返回键码值，在P0口显示-4* 4 matrix keyboard, in the development of on-board single-chip debugging of 51 successful, the return of key code values, I show that in the P0
PWM
- 利用PWM占空比调节功能，进行PB3口LED发光二极管亮度调节效果。-Regulatory function of the use of PWM duty cycle for PB3 I adjust brightness light-emitting diode LED effect.
buttons
- S3C2440,ARM-Linux下的按钮测试代码-S3C2440, ARM-Linux code under the button test
Comm
- 利用16C554扩展串口的时序写程序、读程序 、初始化程序。-Timing using 16C554 serial port expansion write programs, reading programs, initialize the program.
buttons-linux
- 学习linux的必备程序，一个linux底下的按键程序-Necessary procedures to learn linux, a linux under the key program
LCD
- 这是一个单片机控制液晶显示的小程序。显示器上的字回循环显示。-This is a small program a microcontroller to control LCD. The word back on the monitor display cycle.
51单片机实现频率计的程序
- 51单片机实现频率计的程序，产生10个频率。不同频率的计数值：0,100,200,300,400,500,600,700,800,900HZ-The 51 MCU frequency of program
RGB_senser
- 基于单片机控制的颜色传感器巡线扫描源代码源代码.-Scan source code source code based on the microcontroller to control the color sensor line patrol.
4X4key
- 这是一个基于89c52的程序，采用扫描的方式，驱动4X4矩阵键盘。采样并显示。-This is a 89c52-based program, by scanning drive 4X4 matrix keyboard. Sampling and displayed.
NENGYIDONG
- 键盘移位程序，练习时候写的，-Keyboard shift procedure, practice time to write, huh, huh ~ ~ ~ ~
m
- 休闲，爱好，兴趣，对以后学习都有很大的帮助-Leisure, hobbies, interests, after learning has a significant help