资源列表
main
- 用定时器 1 来改变小灯的状态，T1 每溢出两次，1 个 LED 灯闪烁，1 个 LED 灯改变当前 状态。 -Timer 1 with small lights to change state, T1 overflow twice each, an LED flashes, an LED light to change the current state.
8253
- 由STC89C52控制计数器8253产生步进可调的方波，可以通过配置计数器初值改变输出的方波频率。输出的方波可以作为电机的PWM。-8253 by the counter generate STC89C52 control stepper adjustable square wave, you can configure the counter to change the initial value of the square wave output frequency. Square-wave
TLC5620
- 串行8位ADC TLC0831或TLC0832的C语言源程序，串行4路DAC TLC5620的C语言源程序，可以直接使用-Serial 8-bit ADC TLC0831 or TLC0832 C-language source code, serial 4-channel DAC TLC5620 C-language source code, you can directly use
data
- 单片机数据发送程序-SCM data transmission program
zhiliudianji
- 51 & AVR 控制直流电机源码，适合初学者动手入门用-51 & AVR controlled DC source, suitable for beginners to use hands-entry
mine01
- 单片机与PC机串口通讯仿真，基于51系列单片机的c程序-Single-chip serial communication with PC simulation, based on 51 series c program
PWM
- PWM恒速运行的C语言程序，已经调试通过了。-PWM constant-speed running of the C language program, debugging has been passed.
MAX531-DA
- MAX531 D/A测试，晶振为12M，串口方式，参考线必须带电，否则烧片-MAX531 D/A
anjianliushuideng
- STC89c51的程序，关于流水灯，适合初学者学习参考。希望对大家有用。-STC89c51 the program, water lights, suitable for beginners to learn the reference. The hope that useful.
dianji
- 单片机控制直流电机的正反装源程序，通过H桥电路来控制直流电机的正反转-Microcontroller to control the source of the pros and cons of the DC motor equipment through the H-bridge circuit to control a DC motor reversing
led_on
- 基于arm9的led 裸机程序 -Based on arm9 led bare metal program
FIFO
- fifo程序 向FIFO 中写入数据 从FIFO 中取出一个数据-fifo program write to the FIFO data Remove data the FIFO* /