资源列表
mcp3421_example.rar
- 16位AD转换器mcp3421读写时序例程，在实际使用时，上电以后要软件复位一次，此例程经测试完全可以正常使用，已量产.,16-bit AD converter timing mcp3421 to read and write routines in actual use, to power after a software reset, the routine can be tested normal use, has been in volume production.
4-4key
- 基于PIC单片机的4*4按键，矩阵式按键扫描-PIC microcontroller based on the 4* 4 key, key scan matrix
12333
- 基于三星单片机S3F9454电磁炉电压信号采样程序-Samsung microcontroller based voltage signal sampling procedures S3F9454 Cooker
AD_DA5615-1549
- tlc5615，tlc1549 驱动程序，已经调试通过-tlc5615, tlc1549 driver, has been debugged
square
- This program uses the 68681 timer to create a 2 Hz square wave on OP3
999
- 000-999秒表，单片机初学者，希望能帮到和我一样的初学者设计单片机程序。-000-999 stopwatch microcontroller for beginners, and hope to help beginners like me microcontroller program.
8X8ceshi
- 8X8点阵测试实验.通电实验后 可以看到 一根光柱 先从左到右移动3次，然后再从右到左移动三次，在从上到下移动3次，再从下到上移动三次。如此循环。-8X8 dot matrix test experiment
interrupt
- at89c52中断程序，利用单片机内部中断资源实现定时器计数和外部中断。-At89c52 interrupt program, using the single chip microcomputer to internal interrupt resources to achieve the timer count and external interrupt.
pwm_led
- 这是一个51单片机模拟PWM输出的例程,利用改变时间的占空比来调节LED的亮度变化。-This is a 51 single-chip analog PWM output routines, by changing the duty cycle of time to adjust the LED brightness changes.
main
- 51单片机LED16*16中文显示程序，用2个595和2个138-51 single-LED16* 16 Chinese display program with 2 595 and 2 138
TIMER
- 对MC9S12XS128单片机的定时器进行配置启用定时器中断，500ms中断一次-MC9S12XS128 microcontroller timer to be configured to enable the timer interrupt, 500ms break time
TLC5615
- TLC5615的驱动程序，更新速度不能太快，所以在STM32上面的控制需要对时钟处理-TLC5615 driver, the speed is not too fast, so the need for clock control processing in the above STM32