资源列表
JDQ
- 继电器控制,设8255为A口输入,C口输出,延时5s,是否有键按下,若有则转exit,查询8255的PA0是否为高电平,若不是则继续,定时时间到,子程序返回
measure
- 基于单片机nec系统的一些单相电度表电量测量程序,用C语言编写的,自己已经做实验验证过了-Nec single-chip system based on a number of single-phase watt-hour meter power measurement procedure, using C language, and their experimental verification has been done
99
- pid控制程序 pid控制程序pid炉温控制程序pid控制程序-pid control pid control pid control pid control pid temperature control procedures
keyscan
- AVR键盘扫描程序,ATMEGA16 很简练;个人写的,分享一下-AVR KEYSCAN
jianpan
- 一种4*4键盘控制程序,键盘已经编码,在数码管上显示键盘序号。-A 4* 4 Keyboard control procedures, the keyboard has been encoded in the digital control number shown on the keyboard.
18B20
- 温度传感器18B20的源程序。利用此程序能,可以了解18B20怎么用。-Temperature sensor 18B20 of the source. Using this procedure can, you can learn how to use 18B20.
R61505initcode
- 2.4寸液晶显示屏初始化程序,R61505-2.4-inch LCD screen initialization procedure, R61505
RS232-serial-communication-program
- 单片机间的RS232串行通信程序。单片机间的RS232串行通信程序:单片机间的RS232串行通信控制。-Between the single chip microcomputer RS232 serial communication program. Between the single chip microcomputer RS232 serial communication program: the RS232 serial communication between single chip
moteor(PWM)
- 51单片机IO口输出PWM波,控制直流电机转动的速度,特点是简单、好入门,对初学者较好。-51 single-chip IO port output PWM wave control DC motor rotating speed is characterized by simple, good entry for beginners better.
ici3
- 使用ICI自我相消的方法條件下,來觀察使用訊號與干擾的大小CIR(載波干擾比值)的變化-Consumers using the ICI method of self-phase conditions, to observe the use of signal and interference with the size of the CIR (Carrier to Interference ratio) changes in
pwm
- PWM library example for pic microcontrollers.
series232
- RS232串口程序,输入字节,输出所需显示的字符串-Serial RS232 procedures, input byte output the string displayed