资源列表
ADS7886.rar
- ads7886的c51驱动程序，自己写的,ads7886 the c51 driver, written in their own
H-JTAG-config-file-for-s3c2410
- 大学使用过H-flash吗?是不是通过此软件仿真和编程非常方便?比一般的JTAG好得多?但是有时候出现死机,甚至不能编写的情况,本人根据实际的CPU的datasheet编写了两个启动代码: 一个是H-JTAG-SERVER的启动配置代码 另一个是H-JTAG-FLASH启动配置代码 实际上就是设置好一些寄存器. 按照我的这个配置文档来配置偏真器和烧写工具,将会节约您大多数的时间,通常烧写nor flash只要几十秒,当然,现在h-flash是不支持nand flash 的,但是,
pwm
- 一段使用pic16f877a开发的pwm波生成例程-Pic16f877a developed for some use pwm wave generation routines
MOVE1
- 汇编语言实现图像在DOS界面的动态显示，也可做简单修改实现不同的画面，及动作-Assembler language images in the dynamic display of the interface DOS， Also can do a simple modification, and the realization of different picture
Untitled
- 利用模拟信号对能量法进行验证，主要求解振幅值，能量值，频率包络值-Analog signal on the energy method used to verify, mainly to solve the amplitude value, energy value, the value of the frequency envelope
ds12c887
- 时钟芯片ds12887是初学者级实用的一种芯片，在此程序中具体实现了ds12887的串行数据读取等操作-Clock chip ds12887 is a practical beginner-level chips, specifically in this program realize ds12887 operations such as serial data read
autochecklight
- 在使用数码管之前对其好坏进行检测，让各段数码管依次点亮，围绕其绕一圈，可以修改各种绕行方式-The use of digital control testing before it good or bad, so the order of paragraphs digital tube lights around the perimeter of, you can modify the way the various bypass
DS1302
- 基于51单片机和DS1302的实时时钟源程序-Based on 51 And DS1302 real time clock source
initiicm
- PIC子程序。本程序实现IIC主控方式初始化并发送起始位，时钟频率为100KHZ。-PIC subroutine. Way to achieve this procedure initialize IIC master and send start bit, the clock frequency is 100KHZ.
0809
- 一个8051与AD0809的数据采集电路的C程序。-8051 with a data acquisition circuit of the AD0809' s C procedure.
ici3
- 使用ICI自我相消的方法條件下，來觀察使用訊號與干擾的大小CIR(載波干擾比值)的變化-Consumers using the ICI method of self-phase conditions, to observe the use of signal and interference with the size of the CIR (Carrier to Interference ratio) changes in
Test
- This source for arduino test-This is source for arduino test