资源列表
dsp_5509_RTC
- 这个程序是用来控制rtc的工作的程序 使用时，按readme步骤进行-This procedure is used to control the work of the rtc procedures for the use, according to the readme steps
dsp_5509_GPIO
- 这个程序是用来控制GPIO的程序，使用时，按readme步骤进行-This procedure is used to control GPIO procedures, the use of time, according to the readme steps
dsp_5509_EMIF
- 这个程序是用来配置EMIF的例程。 使用时，按readme步骤进行-This procedure is used to the routines EMIF configuration. Use, according to the readme steps
dsp_5509_Codec
- 这个程序是用来dsp5509控制codec器件的工作的例程。 使用时，按readme步骤进行 -This procedure is used to control dsp5509 codec devices work routines. Use, according to the readme steps
wince_arm_CanBus
- CanBus通信实验-Canbus communication experiment
200712020301555_600it
- gps 源码 vb+access 其他地方很难找到 很详细的说明，可以调试运行通过-gps source vb access elsewhere is very difficult to find detailed explanations can be run through debugging
linux_arm_SerialPort
- MagicARM2410与PC机串口通信实验-MagicARM2410 and PC serial communication experiment
linux_arm_StepMotor
- 步进电机控制实验-stepper motor control experiment
4.7_watchdog_test
- void Main(void) { sys_init() // Initial 44B0X s Interrupt,Port and UART wdtimer_test() // test start }-void Main (void) (sys_init () / / Initial 44 B0X's Interrupt. Port and UART wdtimer_test () / / start
4.6_8led_test
- oid led8_test(void) { int i, j, k iic_init() for( ) { for(j=0 j<10 j++) { for(i=0 i<8 i++) { k = 9-(i+j)％10 iic_write(0x70, 0x10+i, f_szDigital[k]) } delay(1000) } } }-oid
4.5_rtc_test
- Embest S3C44B0X Evaluation Board RTC Test Example RTC Check(Y/N)? y Set Default Time at 2004-12-31 FRI 23:59:59 Set Alarm Time at 2005-01-01 00:00:01 ... RTC Alarm Interrupt O.K. ... Current Time is 2005-01-01 SAT 00:00:01
4.4_uart_test
- --- --- ----UART0: 115200,8,n,1------------------------------- Embest S3CEV40 >Embest Info&Tech Co., Ltd. Embest Info&Tech Co., Ltd. Embest S3CEV40 > ---- --- --- ---- UART0 : 115200. 8, n, Embest S3 1 ------------------------------- CE