资源列表
mcupp
- mcu51程序串口输入控制2相4线步进电机的程序，可用撒法-mcu51 procedures serial input control two phase 4-wire stepper motor procedures available Sheva
sy08
- 1． 掌握压控振荡器的基本原理和调试方法。 二． 实验原理 压控振荡器，顾名思义，其输出频率随输入电压的改变而变化。它大致可分为两类，一类是调谐式，另一类是多谐式。多谐式一般线性好，但输出不是正弦波，只能通过间接方式获得。振荡频率一般较低。调谐式多用于发射机中，一般高频电子线性课程会有介绍。 这里介绍两种压控振荡器及其常用电路类型，供大家参考 -1. VCO master the basic principles and debugging methods. 2. VCO exp
juzhenjieshou
- 说明在程序里，里面包括了串口，X5045,定时器程序。-note of the proceedings, including the inside of the serial, X5045, timers procedures.
vs
- tlc2543A/D C51单片机接口程序-tlc2543A / D C51 microcontroller interface program
SQCOMM51
- 51串行令牌格式 a51编译 Read data from serial port and write into buffer DPTR pointed in XRAM if a data frame is received and calculate the check sum if a information frame is received return control byte only -51 serial format A51 compile
clok
- 一个非常简单的而又实用的电子时钟，是用51单片机写ASM原代码-a very simple and practical electronic clock, using a 51 MCU write ASM source code
TMS320C54Xinstructionsytem
- TMS320C54X的指令系统，初学者很有帮助的-TMS320C54X instruction, beginners helpful
arm-bits
- 最好的置位操作函数，是ARM公司源码的一部分-the best home-manipulation functions, ARM is part of the FOSS
ucgui_souce
- ucGUI源代码，非常详细，适合于嵌入式系统的人机界面设计-ucGUI source code is very detailed and suitable for embedded system design of the human-machine interface
C_mod
- 本资料文件讲述了如何将TC的程序移植到嵌入式系统中，附带核心代码-the information document on how to TC transplant procedures to embedded system, the core code fringe
ads7846
- 基于linux操作系统的触摸屏驱动程序，为ads7843驱动程序-based on the Linux operating system Touchscreen drivers, drivers for ads7843
modbus51_c
- modbus RTU 的C51程序 单片机89S52 通信波特率 9600 8位数据 1位停止位 偶校验 485通位接口-Modbus RTU procedures C51 microcontroller communication baud rate 89S52 9600 8-bit data a dual-stop check-bit interface 485