资源列表
okstep
- 单片机步进电机实验,要安装keil_full和proteus 6.5sp5才可以运行(学单片机的应该懂,不用多说)-SCM stepper motor experiment, To install keil_full lic 6.5sp5 and can run (SCM should learn to understand , the answer)
12D_C51
- USB接口芯片pdiusbd12固件源程序-pdiusbd12 USB interface chip firmware source.
A8251
- 8251 端口初始化 包含定义13个输入端口和9个输出端口-8251 port initialization definition includes 13 input ports and output ports 9
cordic_beh
- 这是实现cordic算法的一些源程序,各文件的说明可以参见文件内部注释。 -This is the algorithm Coordinate rotation digital source, the documents of the internal documents can be found in the Notes.
glys31
- 这是一个根据输入信号计算功率因数的电表程序,具有报警和RS485通讯功能;选用电能IC为CS5460A,MCU为PHILIPS的LPC932芯片。-This is a calculation based on the input signal power factor meter procedures, with alarm and RS485 communication function; Energy use for the IC CS5460A, MCU for the LPC932 PH
zl932
- 这是一个输入为0-75mV的直流电表程序,输出显示的最大量程为9999;具有报警和RS485通讯功能;-input 0-H13 DC Table procedures, the output of the largest range of 9999; with alarm and RS485 communication function;
ucos2.76
- uc/os-ii 2.76版本,包括所有的内核服务-uc / os - ii 2.76 version, including all the core services
ADS_Errors_and_Warnings
- arm ads 常见错误及警告集锦。希望对大家优点用-arm ads common errors and warnings Collection. We hope that the advantages of using
PIC16F877_code_1
- PIC16F877单片机运算子程序1.rar-PIC16F877 microcontroller Operational subroutine 1.rar
mc68hc908jb8
- 在MC68HC908JB8上移植UCOSII成功,可直接运行,-on the MC68HC908JB8 UCOSII transplant success can be directly run
microwindows-src-0.91.tar
- microwindow 源代码,嵌入式linux 的图形系统-microwindow source code, embedded linux graphics system
danbaizhishuijie
- 温度传感器18B20汇编程序,采用器件默认的12位转化,最大转化时间750微秒 可以将检测到的温度直接显示到AT89C51开发实验板的两个数码管上 显示温度00到99度,很准确哦~~无需校正!-temperature sensor 18B20 assembler, using the default device into 12, the largest 750 microsecond conversion time can be detected by a direct indic