资源列表
74LC1641602LCD
- 用741lc164驱动的1602液晶显示程序-741lc164 drive with the 1602 LCD procedures
uc_uip
- 运行环境是keil。这是一个实现嵌入式TCP/IP的程序，运行在万邦的w78e516上面，网卡芯片采用的是rtl8019.程序中采用了uc/os提高实时性！-runtime environment is c51. This is a realization of embedded TCP / IP, the running of the IMC w78e516 above, the chip card is rtl8019. Procedures used in the uc / os impr
ucos_application
- 一个UC/OS的小应用，总共三个任务，优先级不一样，重要的是里面移植了一个51处理器，运行环境是keil，大家看看。-a UC / OS small applications, a total of three tasks, not the same priority level, it is important to the transplant inside a 51 processor, the environment is Keil, see.
CAN_ADPE
- 这是一个CAN总线适配器的程序，将CAN节点的数据采集之后通过USB接口传送到上位PC机上去，由于保密性，现在只上传CAN节点的部分程序，供大家参考-This is a CAN bus adapter procedures, CAN node data acquisition after transmission via the USB interface to the upper PC up, confidentiality, only upload CAN nodes part of the
sensortemperture
- 各种温度传感器的详细的编程技术和编程程序，及各个参数的设置-various temperature sensor detailed programming techniques and programming procedures and parameters set
831
- ＡＤuＣ８３１的详细的程序，带有其各个功能模块的程序-ADuC831 the detailed procedures, with its various functional modules procedures
841c_lib
- ADuC841的详细程序，内部ＡＤＣ，ＤＡＣ，ＵＡＲＴ，ＷＤＴ等详细的程序-ADuC841 detailed procedures, the internal ADC, DAC, UART, WDT such detailed procedures
mcs51inUCOS
- ucos-ii in mcs51 system
lwip-1.1.1
- 开源嵌入式TCP/IP协议栈源码，最新版本1-open-source embedded TCP / IP protocol stack source, the latest version 1
stepper_motor123
- 运行环境：FPWIN GR 松下FP0型PLC控制步进电机运行程序-runtime environment : GR FPWIN Panasonic FP0 PLC stepper motor control procedures
tl16c550b_chinese
- TI公司的TL16C550B中文详细资料，可以和DSP或者单片机配合使用-TI's TL16C550B Chinese detailed information, and DSP or microcontroller used in conjunction with
RTOS_developed
- 讲解了几个常用的ＲＴＯＳ的特点，对比说明了ＲＴＯＳ的特点-on several common characteristics of the RTOS, compares the characteristics of RTOS