资源列表
28335 PWM启动AD程序
- EPWM波启动AD采样，包含中值滤波和SCI发送程序(EPWM waves start AD sampling)
apb uvm验证testbench
- 一个apb的uvm验证uvc,可以寄经过简单修改，建立testbench，非常便利，需要在uvm验证环境中搭建uvm验证平台
max30102测试程序
- 用于该模块检测血氧，也可以添加温度，心率等功能(max30102bdrfndtgndtgmndtgmyfgh)
BuckBoost Controller
- 双向DCDC控制器，处理用STM32F334CxT6 互补PWM输出，PID电流电压控制
USB-Mass_Storage-MCU Flash
- 将stm32f103模仿成U盘，将USB口查到电脑上即可识别为一个U盘(Simulate STM32F103 as a U-disk. If you check the USB port on the computer, you can recognize it as a U-disk.)
STM32F030C8-IIC-Slave-master
- 基于STM32F030的寄存器 的 I2C slave 代码。包含dummy read功能(I2C slave code based on STM32F030 register. Including dummy read functionality)
AT426-BU-98000-r0p0-00rel0
- Cortex-M3软核,适用于Vivado 2018.2以上版本(Cortex-M3 IP,suitable for the Vivado 2018.3 or later)
定时器实现流水灯
- 实现STM32基于定时器流水灯功能，通过定时器TIM1控制实现，三个流水灯交替闪烁(Realization of STM32 Based on Timer Pipeline Lamp Function)
TCD1304 driver for STM32F401
- STM32F401RE firmware to drive and read the linear CCD TCD1304 from toshiba. The MCU uses full speed USB and supports continous and single reading of the CCD.
程序及原理图
- 系统中采用了电压反馈闭环，单片机通过内部软件产生一路SPWM控制信号，然后经过逻辑门变换电路变换成逆变全桥所需的四路驱动信号，再经专用驱动芯片TLP250隔离放大后，分别加到逆变全桥四个IGBT的栅极，进行驱动控制。(The voltage feedback closed loop is used in the system, and the single chip microcomputer generates all the SPWM control signal through the i
DC-DC双向供电
- DC-DC双向供电系统，通过STM32F1系列的芯片作为主控芯片，用PWM来控制双向供电
芯达—STM32入门系列教程（15讲）
- stm32单片机入门教程，stm32单片机入stm32单片机入门教程，门教程，(STM32 MCU tutorial,STM32 MCU tutoSTM32 MCU tutorial,rial,)