资源列表
stm32_obd
- 基于ST单片机STM32F10X的OBD程序,是基于底层驱动的源程序，与上位机采用串口通讯，把诊断指令发到CAN网络并返回结果给上位机-Is based on the underlying driver source OBD procedures ST microcontroller STM32F10X based, serial communication with the host computer, diagnostic commands sent to the CAN network a
AVR
- AVR 单片机常的头文件. 用在WinAVR 里面的.-The AVR SCM normal header files The WinAVR inside .
STM32_USB
- STM32USB深入开发详解，STM32F103USB开发一本通-The STM32USB depth development Elaborates, STM32F103USB develop a pass
ht1622MSP430
- HT1622驱动 用MSP430单片机控制HT16-ht1622 for msp430
stm32F107iap
- stm32f107 在mdk环境下的在系统编程-stm32f107 in-system programming mdk environment
lowpowertest
- stm32L151的待机模式的电流测试，开发环境mdk-stm32L151 standby mode current test and development environment mdk
vxworks-bsp-for-cortex-m3
- vxworks bsp for cortex m3-vxworks bsp for cortex m3.rar
51test_code
- 51单片机全套测试代码，十分完整，是单片机学习者的必备资料。-This is a full set of test code for 51 microcontroller , it is very complete,every microcontroller learners should own one.
CLA-CCSv3.3
- F28035的DSP，CCS3.3应用环境的配置，可以在一台电脑上同时打开主CPU和CLA的调试界面，对于使用CLA的并且不习惯使用新版ccs4开发环境的用户很有用！-F28035 the DSP, CCS3.3 application environment configuration on a computer at the same time open the main CPU and CLA debug interface, users not accustomed to using n
LPC1768-controller
- 基于LPC1768的变频器控制程序，根据负载情况，控制变频器的输出功率。-Based the LPC1768 inverter control procedures, depending on the load, and control the output power of the inverter.
CAN-BUS
- can bus 接收发送程序.NXP mcu 内嵌can controller控制器-can bus recieve and send. MCU is designed by NXP, and include can controller.
CS5532_1
- 给自己留着的CS5532驱动程序 开发平台avr 也是搜集的源程序 上传共享-CS5532 using at STM32 platform !this is save for my future using!