资源列表
SpeedMeasure
- 使用LPC2214的测控系统，该系统主要应用于交通部门 -LPC2214 use of the monitoring system, which are mainly used in the transportation sector
51com
- 一个很好的可以用来调试51单片机的串口程序。-a good 51 can be used to debug the MCU Serial procedures.
LPC2104
- LPC2104模拟总线软件包，非常有用的资料啊-LPC2104 analog bus packages, very useful information ah
15AlteraIPCODE
- 15个Altera的IP的源码，嵌入式开发必备-15 Altera IP source code, the embedded development required!
ucGUI_3[1].24_NiosII_JimYang
- UCGUI在NIOS2的移植，，可用-UCGUI NIOS2 in the transplant, which can be used!
ledeasy
- ledeasy,一个简单的LED闪烁演示程序，运行平台为ADS1.2, ARM-ledeasy, a simple demonstration of LED flicker, the running of the platform as ADS1.2. ARM
uart_mx21
- uart.tar, 龙珠i.Mx21上的串口驱动程序，运行平台为ADS1.2-uart.tar, Pearl i.Mx21 the serial driver, operating platform for ADS1.2
usb_mx21
- usb_mx21, ARM龙珠i.mx21上的USB OTG的驱动程序，运行平台为ADS1.2 -usb_mx21 ARM Pearl i.mx21 the USB OTG driver, platforms for ADS1.2
8051xianshi
- 静态显示8051程序， 将预置在显示缓冲区中的6个数置换成相应的显示字形，然后输出到显示器中显示。运行以上程序，数码管将显示543210。-static display 8,051 procedure will be preset in the display buffer of 6% corresponding number of replacement shows font, then the output to a monitor display. Run the above proc
At91sam7s64_startupcode
- 一个很好的Atmel 的ARM的启动代码。（已经调试过了）-a good Atmel's ARM boot code. (Already tuned.)
1602_code_C
- 一个很好的1602的调试程序。用来做人机接口非常的好。-a very good 1602 debugging procedures. Human-machine interfaces used to very good.
Ds18b20_code_C
- 一个已经调试好的DS18B20程序，用来做温度控制的好参考-have a good debugging DS18B20 procedures used for temperature control of a good reference