资源列表
FriendlyARM_GPIO
- Source code written in C to gain access to GPIO pins of the FriendlyARM (mini2440) development board. Source code will blink LED1 on FriendlyARM every second.-Source code written in C to gain access to GPIO pins of the FriendlyARM (mini2440) developm
KEY
- 万利开发板的按键程序。参照《STMicroelectronics32不完全手册》加以修改而成，经测试可用。-Manley' s key development board procedures. Reference to " STMicroelectronics32 incomplete manual" to be modified from, the test is available.
spi
- spi借口通讯，现在的flash一般采用这种双向通信借口，其总共有四种通讯模式-spi the excuse communications, the flash now commonly used two-way communication excuse, its a total of four modes of communication
main
- ARM 的SPI测试，比较简略的测试程序，课用于试验和开发-ARM-SPI test, comparing a brief test program for testing and development courses
SDSDSDS
- S3F9454做的一个ADLFRQ语言源代码-S3F9454 do a ADLFRQ language source code
CalcCRC
- CalcCRC8 The CalcCRC8 is used to append an eight-bit CRC to the message. A successful CRC check results in returning a 0. Implementation: This CRC will be using the CRC-16/CITT protocol. A 16-bit wide non-reflected code that starts initially
main_boot
- 把flash的代码搬移到Dram的0xc-Flash code to move to the Dram of 0xC
pwm
- pwm example for LPC2132
PIC16F946_DELAY
- PIC19F946下的延时测试程序，经过proteus测试能直接放在mplab下运行
Driver
- TI Stellaris ARM Cortex-M3 example code for JTAG lock to protect your code.
frequency
- 测量频率 测量输入信号的频率 测量频率 测量输入信号的频率-measure the frequency
dewPoint.h
- 微处理器开发，计算dewpoint的数值，适用于Arduino等单片机的开发，同时包括其他函数汝转换温度计量单位等。-Calculate dewpoint