资源列表
ST16C554-linux26
- 本代码是ST16C554在Linux 2.6内核下的驱动代码。 从网上查了好多次，都没有找到，只能自己写了。 供各位开发同仁参考。 注意： 本代码有一个缺陷，就是每次收代码只能够收前16个，其余的会收不到。我找了好长时间，不知道是哪里的问题。请各位调好后，给我发封mail告知，我的email:uclinux@263.net。谢谢。-ST16C554 this code is in Linux kernel 2.6 drivers under the code. Online s
spca5xx-20050319.tar
- linux下的摄像头驱动，它是目前支持最大厂商的驱动了-linux under the camera driver, it is currently the largest manufacturers support the drive. .
newled
- s3c2410按键驱动，通过试验已经证实，在linux下面开发的，不同厂商的板子各有不同-s3c2410 button-driven, has been confirmed by experiments in the development of linux Below, Different manufacturers have different plank
AdcNew
- adc转换的程序，经过实践证明，运行正常无误-adc conversion process, proved through practice, the operating properly
Touch_Screen_new
- 这是一个基本的触摸屏程序，优化还需要加去噪声算法。-This is a basic Touchscreen procedures, optimizing the need to increase the noise algorithm.
keyscan_new
- 按键扫描的程序，优化还需要加双重防抖，解释按键的值或者名称-button scanning procedures, optimizing also required to double Fangdou explain the value of the keys or name
AudioDrv
- 音频处理程序，如果+dsp最好了，姑且先用着吧,毕竟能听到过16khz声音的人少-audio processing procedure, if dsp best, given to using a bar, After all, can be heard the voice of the 16 khz less
booting_article
- for arm ,use linux ,boot from u-boot-for arm, use linux, boot from u-boot
uartrw
- linux 串口通信程序,可以设置波特率等,然后通信-linux serial communication program, set baud rate, then communication
armiodriver
- 嵌入式linux上一般的io读写模块,配置为字符驱动程序.-Embedded Linux on the general literacy io module, the distribution of character-driven procedures.
ST16C554-linux2.6.14
- Linux 2.6内核下的16C554驱动程序源代码，工作在68模式下，其中包括驱动程序文档。-the 16C54 driver source code, the 68 model, including the driver documentation.
skyeye0.9.5.win32
- skyeye是一个linux或ucos操作系统模拟器，编译出一个linux的内核后可以用这个软件来模拟。-skyeye is a linux operating system simulator or OUT, compile a Linux kernel after the software can be used to simulate.