资源列表
hardware
- 《嵌入式Linux应用开发完全手册》一书中无操作系统下对GPIO、NAND Flash、LCD、I2C、Uart、MMU等调试程序-" Embedded Linux application development entirely manual," one book, no operating system on the GPIO, NAND Flash, LCD, I2C, Uart, MMU, etc. debugger
uClinux44b0
- uClinux 的44B0补丁，用于040408版的uClinux-dist.-uClinux, a simulation environment, need to extract, compile and install it, compile-time configuration required attention, otherwise unavailable.
u-boot-1.1.6
- 这一个U-BOOT１.１.６的学习笔记，有详细的说明和解释，是学习bootloader的很好的资料-U-BOOT Study Notes
KBDriver
- 基于ppc405eP平台的键盘驱动代码，操作系统为linux2.6.13-Ppc405eP platform-based keyboard-driven code
pca9535kbd.c
- 原创的使用PCA9535芯片作为键盘输入设备的Linux驱动程序，在Blackfin BF548和Freescale MCF54455两种平台下测试过。-PCA9535 chip original use as a keyboard input device of the Linux driver, and tested under the Blackfin BF548 at Freescale MCF54455.
neek_alternate_sd_card_controller
- This SPI-mode SD Card controller is a free SOPC Builder component that can be used in any SOPC Builder system. The included example design runs on the Nios II Embedded Evaluation Kit, Cyclone III edition (NEEK).-This SPI-mode SD Card controller is a
gps
- linux下基于arm处理器s3c2410x开发板的GPS模块的设备驱动程序。-arm processor linux-based development board s3c2410x the GPS device driver modules.
ziku_api
- (绝对原创)Linux写的GB2312字库程序，包括API接口和一个16X16的GB2312汉字字库。接口方便、灵活，可支持不同的大小的字库、不同的字库。支持不同支持的点阵LCD，只需要修改头文件两个宏定义即可。 设计上，借鉴了linux2.6控制台的字库设计方法。API接口和控制台的字库API接口几乎一样，只有接口的名字不同。 配合本人LM6063A、LM12232C驱动程序使用，就是一套完整的显示解决方案了。 /*******************************
linux-study-preview
- 韦东山的书，嵌入式linux开发，部分章节，uboot，驱动-Wei Dongshan book, embedded linux development, part of the chapter, uboot, drive
dosfstools-3.0.1.tar
- dosfsck源代码 主要用于修复 坏的cluster -dosfsck source code is mainly used to repair a bad cluster
source
- 一套完整可在s3c440b+uClinux+miniGUI1.3.3上实现的医疗9参数监护程序程序。-Can be a complete s3c440b+ uClinux+ miniGUI1.3.3 on 9 parameters to achieve the health care program procedures.
SJF_Release
- s3c2416 JTAG fusing tool for K9F1G08,Intel E28F128,AMD29LV800BB. Include userguide.