资源列表
Z-video-udp-sender
- 在基于OK6410开发板上读取OV9650摄像头视频照片，源程序采用QT开发，并利用UDP协议将视频通过网络发送到PC机上-OK6410 development board based on reading the OV9650 camera video photos, source code using QT to develop and use UDP protocol to send the video to the PC through a network
Z-video-udp-receiver
- 在LINUX系统下，采用UDP协议，读取从网络传送过来的视频图片，并动态的显示在QT开发的界面上-Under LINUX system, using the UDP protocol, transferred from the network to read over the video picture, and dynamically displayed on the QT interface development
LEDDemo
- Android开发板项目源码LED控制-Android project source development board LED control. . . .
bsp-nto641-ti-am3517
- QNX的源码，基于AM3517硬件平台，驱动提供源码，方便移植。-the source of QNX for the AM3517 platform.you can use it for your own platform.
jamplayer
- ARM在线烧录FPGA代码 JamPlayer移植-ARM Jamplayer FPGA
SmartHome
- arm9上，基于Linux的Qt实现的一个简单的智能家居控制终端- arm9上，基于Linux的Qt实现的一个简单的智能家居控制终端
gprs_M35
- GPRS的测试程序，基于ARM9的S3C2440处理器与Linux嵌入式操作系统，代码用c编写，测试上海移远GSM模块M35的功能。 -GPRS test procedures, ARM9-based S3C2440 processor and embedded Linux operating system, code using c write, test Shanghai Quectel GSM module M35 function.
faac-1.28
- 音频编码pcm转aac faac源码优化； 支持嵌入式linux平台交叉编译；-pcm to aac faac code
register_editor.tar
- 驱动包含TQ210温度传感器，ADC转换，at24c02等，寄存器编辑器可通过直接写入数值操作寄存器。pc端通过tcp访问开发板，由于qt没有实现IP输入的功能，连接开发板需要修改qt代码中的IP地址。-Drive contains TQ210 temperature sensor, ADC conversion, at24c02, etc. Register Editor by writing directly to the numerical operation register. pc-b
MyCalculator
- 基于Qt界面设计的科学计算器，能完成一半的加减乘除、小数、开方，乘方等-Scientific calculator based on Qt interface design, can complete, decimal, prescribing half of addition, subtraction, multiplication, and division, power, etc
RTC
- LPC1768实时时钟，在旺宝开发板上运行，通过五象键调节LCD上时间日期-LPC1768 real time clock, running in Mong development board, through five as key adjusting date LCD time
Demo.tar
- 指纹模块驱动程序，LINUX USB驱动，经典的USB驱动程序学习例子-A usb drivers of linux for a finger module .It s a classic example for stdudy of linux usb driver.