资源列表
ARM-S3C6410-Development-programming
- S3C6410芯片的相关系统硬件编程，是嵌入式linux开发前提基础学习阶段。-The the S3C6410 chip system hardware programming, embedded linux development stages of learning based on the premise.
4CE6_DAC
- 关于DA转换的NIOS源码程序，已调试，建议在EL-ARM-DSP-IV实验箱上调试。-NIOS source program for DA conversion，debugging on EL-ARM-DSP-IV experiment box.
4CE6_STEPMOTOR
- 关于步进电机的NIOS源码程序，已调试，建议在EL-ARM-DSP-IV实验箱上调试。-NIOS source program for step motor，debugging on EL-ARM-DSP-IV experiment box.
gcc
- 安卓可用的gcc环境，解压至任意文件夹，环境变量与linux上相同，终端模拟器运行-gcc g++ for android
4CE6_IIC_CARD
- 关于II card转换的NIOS源码程序，已调试，建议在EL-ARM-DSP-IV实验箱上调试。-NIOS source program for II card，debugging on EL-ARM-DSP-IV experiment box.
4CE6_HD7279
- NIOS按键源码程序，已调试，建议在EL-ARM-DSP-IV实验箱上调试。-NIOS source program for key，debugging on EL-ARM-DSP-IV experiment box.
smarthome-base-on-SIP-protocol
- 基于SIP协议的嵌入式家庭网关设计，以QQ2440V3开发板为基板，采用linux操作系统，使用zigbee技术设计无线收发模块。-Embedded family gateway design base on SIP protocol，by QQ2440V3 development board for boards, the Linux operating system, use zigbee wireless transceiver module design technology.
Linuxdevicedriver(kernel2.2)
- Linux设备驱动程序(内核2.2)，编写Linux驱动方面很好学习资料-Linux device driver (kernel 2.2), Linux-driven aspects of the preparation of a good learning materials
u-boot-1.3.0_0408
- u-boot-1.3.0移植后可运行于ok2440开发板的代码-u-boot-1.3.0 transplanted development board to run the code on the ok2440
4CE6_DCMOTOR
- 关于直流电机的NIOS源码程序，已调试，建议在EL-ARM-DSP-IV实验箱上调试。-NIOS source program for DC motor，debugging on EL-ARM-DSP-IV experiment box.
4CE6_ADC
- 关于AD转换的NIOS源码程序，已调试，建议在EL-ARM-DSP-IV实验箱上调试。-NIOS source program for AD conversion，debugging on EL-ARM-DSP-IV experiment box.
perl-5.20.0.tar
- 由于最近官网速度较慢。特地上传perl5.20的源码，方便各位下载。-sources for perl5.20