资源列表
SJA1000CAN控制器在Linux下的驱动程序
- SJA1000CAN控制器在Linux2.4下的驱动程序。
buttons
- linux button 应用程序-linux button applications
motor
- 嵌入式开发，给伺服电机的CN1端子发脉冲控制电机旋转。-Embedded development, the servo motor test program to a servo motor terminals CN1 pulsing, drive motor rotation
bdev
- 块设备驱动。为Linux设计一个设备驱动程序，该驱动程序能够用内存来模拟一个1MB的磁盘-Block device drivers
websrfin.c.tar
- Mini2440 webserver with serial port capture
processaproach
- 基于TQ2440的LINUX程序源码，进程间通信测试程序，C语言编写，可在linux环境下交叉编译为arm板上可用的程序-TQ2440 Linux program source code, inter-process communication test procedures, C language, cross-compiler for arm board procedures available in the linux environment
u-boot-makefile
- 主目录中的Makfile、mkconfig、config.mk以及各子目录中的Makefile。因为子目录中Makefile太多，所以本文中以lib_arm目录中的Makefile为例进行分析。 -Home directory in the working version of Tk mkconfig, the config.mk subdirectory Makefile. Subdirectory Makefile too, so this article to lib_arm the
cpufreq-info
- count cpus for Linux v2.13.6.
robot
- 用c语言编写的，适用于在linux内核的arm机上的多路舵机控制程序。-Using c language, it s used to control multi-way steering on the arm with linux kernel.
evm_posix_acl
- Blackfin watchdog for Linux v2.13.6.
nand
- tq2440开发板裸机测试代码 用于测试nand启动大于4K从nand拷贝到SDRAM过程，测试通过。-TQ2440 development board bare metal test code Used for testing the NAND promoter than 4K copy NAND to SDRAM process, testing through.
write_gp
- 进行linux入门学习的巅峰处女作，希望对大家有所帮助，欢迎多多交流-learning portal for linux crested early work, and I hope to help everyone, welcome to conduct more exchanges