资源列表
2010_0709_RT2870_Linux_STA_v2.4.0.1
- RaLink RT2870/RT3070 驱动程序，for Linux up to 2.6.32-RaLink RT2870/RT3070 driver, for Linux up to 2.6.32
W5300_driver-1.2.6
- w5300 driver for MCU
ff9a
- FatFs is a generic FAT file system module for small embedded systems. The FatFs is written in compliance with ANSI C and completely separated from the disk I/O layer. Therefore it is independent of hardware architecture. It can be incorporated into l
ac97_lab
- 嵌入式开发arm芯片的AC97实验代码，已经测试通过-AC97 chip embedded development arm experimental code has been tested through the
ppp-2.4.1
- 经典的ppp程序，适合嵌入式linux下的应用-classic PPP program,which adopts to the application in the embedded system \"uclinux\"
CAN_ldd
- An introduction to CAN (Controll Area Network) by Peter Bagschik and linux device driver code for CAN.
Glade3_tutorial
- 本文简述了Glade3的使用，是GTK新手入门的好资料。-This paper describes the use of Glade3 is a good GTK novice data entry.
pyTarget-1.5.7.src
- 还是一个实现阶段的windows下的iscsi target实现的方法-Or an implementation phase of the windows iscsi target implementation under way
src
- 基于三星210芯片上实现Webserver移植实验以及基于ZigBee无线传感网的远程监控实验。linux-2.6.35.7，中星微摄像头，TI2530zigbee。-Samsung 210 chip-based the Webserver transplant experiments and ZigBee wireless sensor network-based remote monitoring experiments. linux-2.6.35.7, Vimicro camera, TI
cn_usdk130project_compile_envirment_V1.0
- cn_usdk130项目_编译环境搭建与开发板使用-cn_usdk130 build environment to build the project _ and development board
UDPImageArmLinux
- 基于uclinux采用udp通讯协议实现图象等网络规范文件的传输.采用c/s模式,服务器端实现并发而响应多个客户的请求.经过测试,代码能在linux主机之间,arm与arm之间以及pc与arm之间进行通讯(文件中的readme(此为linux下编写)对代码有个总体说明)-use udp protocol communications networks such as image regulatory document transmission. Using c / s mode, the ser
guilin-fengbao-LPC2400
- ARM原理与嵌入式应用——基于LPC2400系列处理器和IAR开发环境[桂电-丰宝联合实验室编著][程序源代码]-Principle and ARM embedded applications- based on the LPC2400 family of processors and IAR development environment [Guangxi Xinhua- Joint Laboratory Fengbao edited] [source code]