资源列表
realarm2410_TFT_lcd
- realarm2410 TFT lcd时序设置 按照韦东山的那边书上的LCD驱动有问题，需要修改一下时序，适用于realarm2410上的lcd-realarm2410 TFT lcd timing set in accordance with the Wei side of the book on Dongshan LCD driver problem, need to modify about timing, the lcd applicable realarm2410
mdobus
- modbus协议RTU和ASCII格式的相互转换，TCP网络上的modbus协议解析和封装-modbus protocol RTU and ASCII format conversion, TCP modbus protocol on the network analysis and packaging
linux 串口多线程程序（驱动gsm modem可参考）
- linux 串口多线程程序,改名为 .c 文件,直接编译即可.
i2c-driver
- 由于海思Hi3513自带的I2C接口已做其它用途，但现在设备需要用I2C接口连接其它芯片，所以，用GPIO模拟了一个I2C接口，附件为源代码,所用的开发语言为C语言。-As Hass Hi3513 comes with I2C interface has been done for other purposes, but now the device needs to connect with other chip I2C interface, so GPIO simulated using a
FrameBuffer
- 基于s3c2410的linux操作系统下对Framebuffer的操作
s5pc100_led
- 两种方法：基于S5PC100的LED驱动。基于LINUX2.6.35的内核。-Two methods: S5PC100 based LED driver. Based LINUX2.6.35 kernel.
ev44b0ii_kbd
- 44b0 uclinux 键盘驱动程序源代码-44b0 Basis keyboard driver source code
minigu
- minigui串口界面的.c程序，可以hi用的-minigui Linux
gpiotool.tar
- pxa270 Linux开发板上用的读取、修改PXA270寄存器的程序-pxa270 Linux development board with the read, modify the procedures PXA270 Register
dm9000x
- u-boot工程网卡芯片DM9000的驱动源代码-u-boot Dm9000 driver code
CFG_DM6467GEM_SHMEM.rar
- c-code for linux driver , used for the configuration of the crxdfg-6431 of Davinci TI processor 6437,c-code for linux driver , used for the configuration of the crxdfg-6431 of Davinci TI processor 6437
s5pc100_pwm
- pwm驱动程序，可以驱动s5pc100开发板，通过设置不同的占空比和频率来播放音乐。-pwm drivers can drive s5pc100 development board, by setting different duty cycle and frequency to play music.