资源列表
linux-wlan-ng-0.2.3.tar
- uClinux2.6上兼容PRISM2.0芯片组的USB设备驱动程序.-uClinux2.6 on PRISM2.0 chipset compatible with the USB driver.
maji_camera.tar
- onmivision 摄相头模块驱动程序,blackfin 平台参考设计.-onmivision perturbation is the first module driver, blackfin platform reference design.
rt2571.1.1.0.tar
- 经过修改的在uClinux2.6上正常运行的ralink rt2571芯片组的设备驱动程序.-revised uClinux2.6 on the normal operation of the chip ralink rt2571 The device driver.
GNUMap
- 这篇文档介绍在Linux下用GNU工具集开发ARM程序的一个机理-This document describes the use of GNU Linux development tool set procedures for an ARM Mechanism
Epson_printer_driver
- 嵌入式linux打印机驱动EPSON系列-Embedded Linux printer driver EPSON Series
G711law_pcm
- G711 u-law, A-law and linear PCM conversions Programm.
710x_resource
- 包含了st710x开发板的所有源程序代码-contains st710x Development Board all the source code
spioc
- it is character driver -driver
sndtools
- 声音信号的采集和回放，将采集过来的音频信号再播放出来-voice signal acquisition and playback of the audio collection over again broadcast signal
uCOS_uClinux
- 嵌入式操作系统是嵌入式系统应用的核心软件。本文通过对两种典型的开源嵌入式操作系统的对比， 分析和总结嵌入式操作系统应用中的若干问题， 归纳嵌入式操作系统的选型依据.-Embedded operating system for embedded system is the core software. Based on two typical embedded operating system revenue contrast, Analysis and Lessons Embedded oper
s3c2410base_experiment
- 这是s3c2410的几个基础实验代码,在ads下编译通过,上机调过,能用-s3c2410 This is the basis of several experiments code, compile under ads, on the plane emphasized that speaks
9315
- EP9307程序 非常珍贵 ------EP9307程序 非常珍贵-EP9307 procedures precious ------ EP9307 precious procedures